Recent content by xman_charl

central machinery drill press, about 15 years old, grizzly about 8 years old Motors are 90 volt DC

modified hf belt sander several years ago motor is 1 1/2 hp, 3,500 rpm with pulleys..rpm is 2,700 use 6x48 inch zirconia belts Charl

this utube ...gear show.. excellent videos of rebuild of battery packs for old drills Charl

nice to see a fellow from my area... live over in Vallejo... Charl

quick mount for grinders, strong pins... bought 2 of these grinders, for $80.... when enco was shutting down Charl

ground 3/8 drill with my tool grinder... sure is fast, compared to hand grinding, pedestal grinder Charl

modified work holding table sure works good... Charl

G0602 Lathe Horror home user...turned on lathe....crack, click, click, bahm!! cannot run lathe like this!!! disconnect all belts, turn motor on, crack, click.... definitely Grizzly motor shined flashlight back of motor could clearly see fan not moving properly... took out motor...cracked...

Use these in my bandsaws... Titanium 6Al4V: Lennox p/n 12897D2B51638, 6-10 variable tooth bi-metal, 0.025" Charl

found this articulating lamp thingy... put a led lamp on it Charl

my bench drill press table... Charl

bought my new house about 15 years back bought because it had central air and heat old place did not air condition never worked right repair people from manufacturer would add Freon works for a few months, then hot air so 3 years ago called a1 heading and air, they adv on tv sometimes a1...

vallejo, Californa says hello Charl

got this pack of chargeable ni-mh Pack of 16...think it was $23.00 sure work good for my CCrane pocket radios https://www.amazon.com/gp/product/B007B9NV8Q/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1 Charl

got this 20 or so years ago.. just 2 pulleys for belt...what a pain to drill with those speeds now its go 3 pulleys and dc 1 1/2 hp 90 volt motor Charl