Recent content by ZekeTheSneak

I have the 56" and I think I would have gone a different route. The power drawer, with the plugs is useless to me. I would rather have two small drawers. The really wide wrench drawer should be two drawers. The the tall drawer second from the bottom should also be two drawers. I like the gun...

Free is always the best price lol. It was more like 5 bucks all things considered. I'm going to disassemble it and see what I can find out about it.

Just purchased this arbor press for essentially free, Has no name or markings. I found one similar. Appears to be a Yuasa International? I am curious to learn anything about it. 1/2 ton? 1 ton? Hot garbage? Won the lottery?.... Thank you,

now i know what that bit is for lol.

Same the new harbor freights need the option. Or to sell small drawers separate but thats annoying

Speaking of Steve. Hell of a guy!

I dmed you I hope. Thank you

No bueno. Thank you. I figured there would be a blow molded set thread or something

Looking for craftsman catalog from 2006-2007 Is there any online link to the 06 07 craftsman catalog? I am looking for a specific blow molded socket set. 3/8 metric. Had sockets, extensions and a couple double ended wrenches iirc. I looked through the 2008 catalog and that's when they went to...

Evolution R255SMS-DB+ Miter Saw, anyone have one? I need a few measurements of the fence bolt spacing. I'm looking to upgrade the fence on my evolution rage 3 double miter. I'm pretty sure it will be plug and play by want to verify if possible... Thank you...

It would be too tall. Trying to fill the void above my sunnex prybar box. Any ideas welcomed!

Why is he hated? I also saw that same video lol.

I have a second gen harbor freight 44" bottom and top toolbox. I am looking to add a small cabinet onto the side. Doors would be 90 degrees off of the drawers. So it would open from the side of the toolbox not the front. Has anyone done this and can recommend a cabinet? I found this cabinet, I...

I have a spare block and pistons. I need to measure out of round, and taper. Then I need to measure the pistons I have to see if they are still within spec to the block. Hoping to get away with a light hone and reuse the pistons that I have from the same holes. There is still cross hatching and...

What resolution is safe for metric? .01mm or .001mm? Having a tough time finding anything over .01mm graduation. I will be measuring piston skirts, crank/rod journals If what I am understanding from YouTube videos when using metric .01 is very accurate and when you go to standard you want to go...