Search results

I am in as well as long asshipping is reasonable. Aquaticbob, Thank you in advance for all your time and efforts to put this together. I have participated in a group drill bit buy through garage journal a few monthes back and was extremely pleased.

Welcome and good luck on the future build.

Calcium chloride

Something else to look into, where is thermostat located. I venture to guess closer to the warm area and the furnace. Look at duct work close to furnace, you should have dampers that could be adjusted to provide less heat close to Tstat, thereby allowing furnace to run longer and warm distant...

Welcome from Michigan

Can not tell what type of material wires are coming through. If it is concrete, you could try hydraulic cement. I have had excellent results even stopping flowing water.

Just wanted to take a minute and thank PT Doc for his efforts. I will be placing an order this week.

Look into a vfd, variable frequency drive, single phase 240 in, three phase out plus infinite speed control by changing frequency either higher or lower than standard 60 cycles

Refractometer, much more accurate, but expensive too.

Yes, we cut reinforced concrete all the time. Wire or rebar it doesn't matter

Want it to last? Black walnut has lot of natural oils, my sawyer recommended it to me.

Interested in a large screwdriver set as well

Welcome from the capital city

Welcome, I am in Lansing

It is the same in the center of Michigan too, Lansing. Lowes almost never clearances here.