Search results

This is most likely your best solution. Commercial mortice locks come in hundreds of different configurations and are expensive.

I prefer WD-40 for aluminum work! Not as stinky.

Look for a used architect horizontal file

Thanks for the murge. Wasn’t really sure

Could have been, but it was getting pretty long🤪

Bored out the offending collet holder to MT3. Still waiting to some tooling to “fix” the draw tube end.

Im with the leave it alone camp.

Had a neo magnet the size of a hockey puck. Kept it inside a plastic tool box with more foam than that all around. The whole box could be stuck to anything!! That thing could hurt you if you weren’t careful!

Use zip ties to hold it together as you rewind it.

I did find an ebay seller that claims to sell the correct collet. But don’t want to wait another minute for shipping! Going to convert it to a 3c. Ordered a 3C to 5mt adapter and a draw tube from little machine shop.

Sawset?

“Dreess”’the scotch brite wheel with a 36g flap disk on an angle grinder.

Have a HF Vulcan 201 I believe at work. My coworker welded up some aluminum square tubes with it. It was his first time. Actually turned out pretty well.

Ya I picked the 25. Bigger is better right?

Thats what i thought too! Seemed a little off though. Might try one, haven’t found a good source yet.

Ya, thought that may have been the cylinder for e or size.

Ya, was not expecting a lot! Was betting on it being a 5c. I’ve gotten a few cheap spindexers all have been 5c.

Well im not sure what to search for now?