Search results

Posted from Garagejournal.com App for Android

Thank you all for your responses, I appreciate your wealth of knowledge. Would production of this lasted till the end of the war? That's my understanding of about when it would have been purchased. Does anyone know how to get the screw out? Also, anyone know what the original finish would have...

Hi, I was wondering if anyone could identify or tell me anything about this vise? I am planning to restore it and attach it to my (future) workbench. Thanks everyone.

looks good

sending pm...

Sending a pm about the kcs

Growing up in my fathers pallet shop Ive shot quite a few coil nail guns at things other than wood. I don't know about the new ones but the old guns you could hold the head right and fire them on automatic. Ran off more than one scumbag that way, killed a couple birds too. *don't try this at...

did you check that the relief isn't open some? We've gotten some for free that were"broken" and all they needed was the relief adjusted a bit.

I always use the K&N oil filters, good filter plus it has a hex boss on the bottom (3/4" iirc), I just reach up with a stubby and spin her on and off, your son may need something bigger (no offense intended) but its by far the best design Ive seen for putting them on and off.

get your lawyer on the phone, snap on should owe you some royalties :lol_hitti seriously though, sorry about your wrench

I got this > clicky ryobi for Christmas, I use it for some minor wood working, sharpening tools and weld prep on small pieces of mild steel, I like it a lot, the base is quite sturdy and after 5-10 minutes of dialing the belt in when I first got it I haven't had to mess with it at all. Its also...

welcome, Ive been a long time lurker on the hamb as well. lots of good info here, sorry I cant give you any constructive advise on dealing with a HOA and not going to jail

inside because the neighbors would get even more pissed off if I put it outside.

There's an entire subforum devoted to this :thumbup: just seems to reiterate how you haven't spent 30 seconds considering that you are joining a thriving community which has done quite fine without your omnipotence and leadership for some time now.

gonna leave everyone hanging like that? especially with the bait of an easy out that my actually be easy or get things out?

Payment sent. Thanks, I cant wait

I'll take the hand grinder!!! Will it fit in a large flat rate box? Please pm me and let me know a total with shipping to 17554. Thanks.

good job on your first try at tig. I am still trying to learn as well.

Either keep practicing or move the cab so you can access the area you need to easier. nothing says you cant flip it up on its side :thumbup:

^ Don't you love Pa's convoluted laws? When it comes to things like that I've chosen to just go ahead and ignore them.