Search results

I have decided this is going to be my setup in a 40x36 garage that was constructed a few years back. It has the needed 2" insulation under the slab along with 1/2" tubing in 5 runs of 1370' total. I only want a single zone. I would like to use a Ecobee thermostat so it can be monitored on my...

Has anyone every seen or used a RJ7 on the HD9 4 posts? I know the sites says the RJ4500 are made for the HD9's, but I might have access to an RJ7 for cheaper than a 4500 to use on my HD9 lift.

I have the dreaded i-Drive garage door openers in my current garage and for the most part they have worked fine for over 8 years now. This past summer both of the light fixture assemblies won't turn on. In the past I could reprogram them or replace the bulb with no problems. You can still...

I have been reading through the install manual for my HD-9XW lift and one odd thing I noticed was the need to have the posts standing upright and lifting the cross tube over the top and then dropping it down to the bottom of the posts. I'm going to lay my posts at a 45 degree angle supported...

I ended up getting the HD-9XW and just started to unpack things this week. I want to install a safety stop switch on the lift. I know I read a thread on here where there was a few pictures and links to what works the best for a 240v install but I just can not find it. Anyone install something...

I have decided to go with the Bendpak HD-9 series of lifts. Any recommendation on who to buy from? I have talked with a few local places with no great deals plus sales tax and shipping is not an issues since I have access to the equipment to unload the lift.