Search results

Anyone use Rapidair regulators? I just bought a new compressor and was looking at these since they are rated for 175 psi. TIA Chris

Is there a limit on the amount of lb conduit bodies you can have in a run? im trying to lay out my conduit and i am looking at 5 in about a 70 foot run. thanks Chris

in order to get wire from my panel to my enclosed porch, i have to go out of the house literally the length of a conduit body and then into the porch. so just to make this 6-8 inch jog, is uf required since its outside for that little bit? or can i legally get away with nm cable? thanks

Can i drill a 1 1/4 hole through 4 x 6 roof rafters of my breezeway? i need to drill all 4 of them. the wall is about 9 feet long with just a roof, no second story. Thanks.

So i was contemplating my electrical run, and got to thinking. My house is attached to the garage via breezeway. So does this make it attached or detached? My concern is needing to be concerned about firewall breaching, or ground rods. Is this all up to the ahj? TIA. Chris

Can a ng line be run hidden in a bulkhead? i can run a line to my garage through the breezeway and mount it on the wall. i would like to box it in, so you dont see it at all. is this legal? thanks in advance Chris

good morning all, i am reconsidering my subpanel project, and had a question. can i run ser through a wall like nm? my house is attached via breezeway to the garage, and it would be cheaper to run ser through the basement and through the connecting wall. (shorter run, no thwn needed). is...

Is there a maximum distance that the ground rods can be away from a subpanel? And can they be covered in concrete once installed or do they have to be accesible. Thanks in advance. Chris

looking to add a 9x7 door to my existing garage. what size header will be required? can i use doubled up 2x10s? thanks in advance. chris

I need some help guys. i have a single 20 amp gfci outlet in my main bathroom, previous home owner tied ran another 20 amp line up to the upper half bath. Is this legal per NEC? Thanks in advance. Chris

whats the biggest circuit i can run through one inch pvc approx 40ft? thanks in advance. chris

i have a snap on kra4107b, that needs drawer slides. i cant find them on the snap on website to get them warrantied. the part number on the current slides are 8-2388A. does anyone know if there is a updated part number for this? thanks. chris

Model number BTW200, with case, charger and one nm-hi battery. A little dirty, but still works good. Paid over 500 when bout new a couple years ago. 225 shipped to the lower 48. Thanks for looking. Chris

I am currently redoing my bathroom, and the toilet line comes right up thru the floor. what i want to do is move it back, so it comes out the wall behind the toilet. however there is an outlet box from the adjoining room in the wall space where i want to put the plumbing. there would be about...

Hey guys, over the course of the winter two of my trash cans filled with water, and before i knew it, they were both stagnant and nasty. Any ideas on putting anything in them before i dump them to maybe take the stink away? Any ideas are appreciated. Thanks. Chris

Did the search, and couldnt find specific threads due to the 3 letter minimum in the search feature. So what i wanted to know, is whats everyones opinion on SK sockets? Torx, hex, impact whatever you use, are they as good as big truck brands? I know, I know.....most are going to say not as good...