Search results

Search the forum Search Articles
  1. J

    Looks like sand coming out of heater

    Small electric heater to keep my shop from freezing up in the winter. It has some sort of sand looking stuff coming out of it. It is a cheap heater so wondering if it's the heating element coming apart. What is this stuff?
  2. J

    Snap On Techangle torque wrench 1/2" drive

    Never used. Has a few small scuffs from being set down that are pictured.
  3. J

    Semi tubular rivet tool

    What kind of tool do I need to set these kind of rivets? https://www.rivetsonline.com/rivets/semi-tubular-rivets Put on a new awning on my race hauler because old one collapsed in a storm and found one of the rivets broken. Purchased new rivet and trying to figure out how to set it.
  4. J

    Snap On Techangle torque wrench

    Snap On Techangle 1/2" torque wrench ATECH3F250VR. Never used to torque bolts. Small scuffs on bottom where it was sat down.
  5. J

    Williams 3/4" torque wrench HTW4RCF

    This was given to me about 15 years ago after the company I worked for used it as a breaker bar. Would this be worth repairing?
  6. J

    Lifting a flatbed dually on a 2 post lift

    I have a couple of duallys, one being a flatbed that I built and the bed is heavy. Should I adjust the recommended lifting points for this? 95 F350 with a 460 and it is a regular cab 2wd. Bed is 8'x10'. I have a Bendpak XPR-10S two post lift.
  7. J

    How to adjust BendPak 2 post lift

    Installed lift and everything is plumb. Just can't seem to get the locks to click off at the same time. Do I set the cables with a car on it or empty? Any tricks to setting the equalizer cables? Thanks, Mike
  8. J

    Bendpak XPR10-S 2 post lift install

    4'x14'x12" concrete, 10" anchors.
  9. J

    How do I use what I think is a ball joint press?

    Says Miller Tools 9945. It was given to me as I work on a lot of Jeeps. It doesn't come with instructions but has a pamphlet in it that says Jeep JK (Wrangler 2007+) on it. Thanks, Mike
  10. J

    Started cutting concrete for 2 post lift.

    Picked up a Bendpak XPR-10S. The concrete was cracked around where the post would go so out it comes. Following Mohawks guide for concrete size and rebar structure. Going to starting digging it out tomorrow. https://www.facebook.com/rick.lapkovitch/videos/866323993520847/?fref=mentions
  11. J

    Two post lift pad setup

    Just ordered a Bendpak XPR-10s two post lift. I do not trust my pad to be 4" and have some cracks near where one of the posts is going to go. What kind of area and how thick should the pad be that I replace it with? I and going to cut out and pour new concrete under where the lift posts are...
Top Bottom