Search results

I'm in the process of running some new electrical in my garage. I cut an access hole in the ceiling to allow me to run the wires. I'm adding an FUH54 heater and realized the ceiling wasn't insulated by the builder, only the area above living space is. Can I just lay insulation sheets down like...

Trying to figure out the best way to run wire through an I-Beam flange. I need to come down from the ceiling down the wall and get into the bottom I-Beam webbing which will allow me to enter the basement. From what I have read, you cannot drill holes into an I-Beam flange. If thats the case, how...

Ordered an FUH54 from Blains for my 20x20 garage. I need to wire in 2 220 lines, one for heater and one for lift. Both need 30 AMP. Can I wire up a 4 wire dryer receptable 14-30R but use 10/2 wire and just leave the neutral not connected? Should I be using a 10-30R instead but loose the ground...

Ordered an FUH54 from Blains for my 20x20 garage. I need to wire in 2 220 lines, one for heater and one for lift. Both need 30 AMP. Can I wire up a 4 wire dryer receptable 14-30R but use 10/2 wire and just leave the neutral not connected? Should I be using a 10-30R instead but loose the ground...

I like to work on my 2 Mustangs during the winter. We usually hover around 35 - 45 degrees here in the southeastern PA. Been colder then normal this year. My garage is 20x20 2 car garage, 2 walls are insulated. One wall with a window and side exit door is not insulated. Front wall with 2 doors...

I've been lurking on the forums for months and could use some help. I'm adding a 4 post lift to my garage which has 12 ft ceilings. My garage door uses extension springs and tracks are right around 88" from the garage floor. My opener is centered at right around 7' from the floor. There is no...