Search results

Connet a water dispenser bottle to water supply Hello, I use a top mounted hot and cold water dispenser with a 3 gallon bottle as it short enough to fit the water dispenser with bottle installed, underneath cub-bards. It provide hot and cold water. Since I live next a rural district water...

I have several Kennedy tool boxes I'm going to restore. However I'm not certain about what sort of paint to use and what sort of preparation work is required. The first one is brown and the top fold open with small compartments on either side. Is going to require some straightening of the main...

I came across a wet sandblaster a couple of months ago for around $25.00 on a single website that had a 1/4 inch quick connect to connect the wet blaster to a pressure washer, but haven't been able to find the website since. I know there are wet blasters (designed to connect a a pressure...

I have a 240 volts GE Smart Water Heater. GE50T6EA Specs shows it's a dual element Upper 4500 watts Lower 4500 watts --------------------- Total 4500 watts (uncertain why total shows 4500 watts since it's 2 x 4500 watts) Wire connections on top are a red wire and a black wire. The wire...

I have this clamp meter adapter that's used with a multi-meter and trying to figure out if it's working. I don't have the instructions. The front besides the p/n has (Output 1mV/A) I connected the clamp adapter to my Fluke meter and place the clamp over one of the AC lines (connected to...

Hello, I have a Fowler electronic caliper that came as part of a drum and rotor measuring kit. Must have purchased around ~10 or more years ago. The kit at the time selling for around ~$75.00 - ~$85.00. I think prices have fallen since, to around ~$40-$50 for a complete kit with caliper...

I needed some additional hex bits for a project. Many of my tools are Craftsman but have a few industrial quality tools picked up from factory auctions. I haven't looked at hex bits for quite a while. After looking around at hex bit sets I ran across both good and poor quality, where most...

Hello, Irwin and other manufactures produce an 1/4" square to 1/4" Hex adapter. Does anyone make a 1/4 inch (6.35mm) Square to >> 5/32 inch (4mm) adapter? __ (below is a pic of a 1/4" square to 1/4" hex adapter) I'm looking around for a 1/4" (square) TO 4mm (hex) adapter to use (4mm)...

I haven't owned or ever used an air compressor. Most of my tools are either hand or power tools. However I decided in order to do some work I'm going to need a sand blaster to clean up a couple of vehicles. Where a wire brush, wire wheel, grinder, navel jelly aren't going to be enough to...

Proto 6008 torque wrench ... 5 to 75 ft/lbs .. 3/8 inch drive. This is an older used torque wrench ... Calibration should be around +/- 4% ? Anyone know how to calibrate the handle ... i.e. there is an adjustment screw inside the hole in the handle or the entire handle needs to be dismantled?