Search results

I am looking for a door opener for my shop. I h ave a 10x12 door with high tracks. I would like the type that installs on the wall at the top of the door like you see in commercial buildings. What are they called? Not even sure what to search for.

I have a pole building/shop (40 x 48 x 16) which I want to re-organize. I currently have my welding table (4ft x 3ft) against a wall with several 50 amp outlets for my welders. I keep my mig (lincoln powermig 256) and tig (lincoln square wave 200)/plasma cutter on each side of my table, always...

Not sure if this is the correct spot to post this. I am going to build a roof rack for my van out of aluminum round tubing. Wont have a ton of weight on it (factory supports only allow total of 624 lbs) but would like to be able to climb up ladder to it and stand on it while loading. Does...

Last summer I had noticed I had mildew/ fuzzy mold grow on everything in my shop and some rust issues. I assume it was because of humidity and condensation but not sure. here is what I am dealing with 48 x 45 x 16' pole building. built on 4"slab (no vapor barrier underneath:mad:). walls...

Ok, I know this may seem real basic to most of you but I want to make sure I am hooking this up right, I am not the most knowledgeable about compressors. I have an IR 5hp, 80 gal compressor and want to hook up a moisture minder auto drain valve. As I understand it I should hook this up to the...

I have a new pole building. I have 5 high bay lights which I have purchased previously. They can be wired 110 or 220. Any benefit to one over the other? I am going to put them all on the same switch. Could anyone draw a basic diagram to wire them to the switch using 220v? Do I daisy chain...

I just had a new shop built, its 48 x 60 pole building, I am going to section off 20 feet of it to complete my shop which will be heated. It has 16ft ceilings. My final shop dimension will be 20 x 48 with one 10x12 door on the 20ft end. A few questions: 1. Insulating the walls. I was...

I have a detached garage which currently has 100 amp and my generator backfeed lines to the house. These are all buried in conduit. I want to redo my patio in the back and need to move the conduit back about 15 feet further, I know the current wires in it will be too short by about 10 feet or...