Search results

Tried searching and couldn’t find something this specific as what I was wondering. I was going to get a 1 gallon sprayer and convert it to a fluid transfer pump, in particular for ATF and Differential Fluid changes. I know cross contamination is bad. Assuming after use I spray the jug out with...

I tried searching but it’s such a niche question I had no luck. I don’t have an air compressor and have all battery powered tools really. Unfortunately, I’d love an air hammer as there is no real battery powered equivalent without getting a massive SDS style drill. Air compressor would also be...

I currently don’t have any type of vise at home and it’s certainly annoying. I don’t have a work bench to mount a bench vise too and I prefer to keep my two car garage for parking cars. When I do work on the cars or if I need space in the garage, it’s nice not to have it cluttered with ****. So...

What I have: So I have slowly been upgrading my tools and I’ve put off the wrenches for a while due to cost. I have a set of metric and SAE USA Craftsman raised panel wrenches that came in a mechanic tool kit I bought ages ago. They only go up to 15mm though. They also aren’t very long. I then...

Hello all, I have read a lot of reviews online of DMM's as well as posts on garage journal. Was hoping to get your direct feedback on recommending a DMM. My last DMM was a Radioshack one I bought in 2009 out of college, and it finally crapped the bed. My use cases are working on my car, house...

Subject pretty much says it all. I don’t have a cutter for a nice square clean cut on a coolant hose, nor one to use on PEX lines. I was hoping I could buy one tool to do both jobs since it’s basically both just plastic/rubber tubes. Does anyone know if I can use one tube cutter to do both jobs...

Hello all. I was doing some research and was trying to find a good magnetic impact nut setter with a 1/4” shank for my M12 impact driver. Was curious if anyone had any recommendations. Metric and SAE would be nice but I really only need SAE most likely. I was thinking for odd jobs where I help...

So I fully understand why they make left and right hand twist on drill bits. And I get why most Mechanic’s Length Cobalt Bits are left hand twist since normally if you’re drilling and need that short bit it’s for car work and you’re dealing with a stuck bolt. So if you gotta drill it out anyway...

Hello, I tried searching and couldn't find much, so I wanted to ask people's opinions. I know very little about hacksaws and have little practical experience using them. I don't really own any saws at all as I normally will just use a cutoff wheel: Dremel for small stuff a Milwaukee 18V 5" Angle...