Search results

  1. A

    Framing an office in a pole barn

    Having a pole barn built. 24 x 40 x 10. I plan on framing up an office in the back corner 12 x 10 x 8. The pole barn is being built with r19 in the walls and metal liner panel. What's the best way to tie this room in? I can remove the panels in those areas if need be.
  2. A

    Hand cleaning brush

    I've seen plenty of threads on which hand cleaner to use but can anyone recommend a good brush? The typical nail brush from Walmart isn't the best and doesn't seem to last long.
  3. A

    24 x 40 shop build in NJ

    Hey guys been following on here for a long time. Getting ready to break ground for my shop in a few months. I'm a 34 yo HVACR contractor from South Jersey. I purchased my home in 2010. I have a 3 car detached garage that I've been working out of but its Just too small. Unfortunately, I didn't...
  4. A

    Pole barn roof vapor barrier

    I'm having a pole barn built. Originally the plan was to have a vapor barrier installed on the roof to prevent condensation. I've since decided to have the pole barn co insulation the walls and roof and close them in with a steel liner. They say walls will be r19 faced insulation. Celiing will...
  5. A

    Wiring pole barn

    Hey guys. I'm getting ready to have my 24 x 40 pole barn built in a few months. I'm going to be pulling a permit and doing the wiring myself. I'm an hvac/commercial refrigeration contractor by trade so I have plenty of experience with high voltage wiring. I want to make sure everything is done...
  6. A

    Setting grade for pole barn

    I'm having a pole barn built in a few months and am getting ready to get my lot level. My concrete contractor asked that I put down 5 inches of crushed concrete so its all ready to go once the barn goes up. I'm getting a load of dirt and a few loads of crushed concrete so I can level the space...
  7. A

    Pole barn suggestions

    Hello. I'm building a pole barn on my property. I own a small hvac business and have outgrown my detached 21 x 36 garage. I was looking to build a 24 x 32 x 10 building with a 6 foot lean to on one eave and a 9 x 9 door on one gable. I mainly want to use the garage as a shop for welding sheet...
Top Bottom