Search results

Is there a toggle switch I could add to this for my on off switch ? Is there one rated for this application? Sent from my SM-G930V using Tapatalk

For the low oil cutoff 2 wires and the pressure switch 2 wires tell me if this is correct . One wire from the low oil switch goes to L1 One wire from pressure switch goes to A1 The second wire from both get wire butted together ? Sent from my iPad using Tapatalk

Edit.....I see what your pointing at now . I'll go back out and check if that's a ground screw , sorry Sent from my iPad using Tapatalk

Got the jumper wire installed Sent from my SM-G930V using Tapatalk

Is this what you were looking for ? Sent from my SM-G930V using Tapatalk

Ok so power lines in to L1 and L2 , jumper from L3 to T2 . Motor wires are T1 and T3 . I just get confused on the coil portion with the pressure switch and low oil wires. Please forgive all the questions , this stuff isn't my specialty . Might take a little bit but I just wanna do it right...

Wyliesdiesels...just in case you don't check private messages ....Wiring my starter box help You've been a big help on my post about wiring my motor starter. Lemme see if I understand this correctly . Power feeding the motor starter go to L1 and L2 . I need a #6 jumper from L3 to T2 so it...

More views in case u need them Sent from my SM-G930V using Tapatalk

96 wired from the factory goes to L2 and 95 from the factory goes to one leg of the coil which is 230 volt coil Sent from my SM-G930V using Tapatalk

No no I'm not on 3 phase . Single phase here . I have my own transformer and it only takes 2 of the 3 legs . This is a single phase 10hp 230v motor I'm wiring Sent from my SM-G930V using Tapatalk

According to eatons website literature charts this model # is a 10hp single phase 230v starter Sent from my SM-G930V using Tapatalk

I also spoke with one of my buddies who works for the power company (lineman 10 years ) . He said no hp limit that he knows of , said with my service , being on my own transformer there won't be an issue . Sent from my SM-G930V using Tapatalk

In regards to the starter it is listed as a 10hp single phase 230 volt starter, overload protection from 40-57 amps adjustable Sent from my SM-G930V using Tapatalk

This is where I'm at so far , just gotta finish hooking it up tommorow . I got all the new wire installed from the pressure switch and to the motor Sent from my SM-G930V using Tapatalk

Can anyone verify if this is the correct wiring for the motor starter , circle on the left says low oil switch , on the right of box is pressure switch , thanks Sent from my SM-G930V using Tapatalk

The transformer is right in my front yard, and right above it is the 3 phase lines feeding the big farm down the road Sent from my SM-G930V using Tapatalk

I have a 200 amp main service , and I'm the only drop from the transformer Sent from my SM-G930V using Tapatalk

So 60 amp is safe and might work fine , 6 guage wire is 0k , just might trip breaker? Sent from my SM-G930V using Tapatalk

Sounds good to me , thanks Sent from my SM-G930V using Tapatalk

I guess I would go with 6 guage wire and try the 60 , could always go up to 70 and be good with the wire I guess Sent from my SM-G930V using Tapatalk