Search results

Besides the high dollar cutters, what can the DIY guy use to make simpler?

Unfortunately I have T12 8' single pin lighting. Is there a better/cheaper replacement ballast than the current?

Currently have painted hardboard thats ancient. Thinking of some other options for the makeover. Seems like can lights are becoming more popular in the garages too. I like the looks plus more energy efficient.

Going to rewire shop soon. Very old building and wiring is old and have some questions. 3phase main going to 100amp sub. Only 3 wires goung to sub. 2 hots and neutral. Theres a ground from sub to outside to ground. This is attached to the one and only neutral/bus bar where grounds and...

Ive done a little research and seen its possible. I have 9' now and being able to get a hoist would be great. Block construction so im thinking that would make it an even better candidate. Ive been up in attic and the building was built like 1920 without trusses. Ill have get a pic. Its about...

Liwes has 250' roll of 14/2 nm for $38.97!! Whats the catch?

Im going to run a circuit entering a single pole switch then branch off into some shop lights. Im pretty sure i know but just like check. I can then branch off one of the lights to power a separate switch that will feed a bathroom light by simple middle of run switch wiring, correct? Not...

Whats specs for running wiring through attic space in garage? Does it have to be stapled down and if so whats spacing? I have some exposed NM wiring secured to ceiling ivwantbto clean up. Thx. Mike

Copper line on my Craftsman 4 gallon, twin tank, 916638 cracked in two. I can't get a replacement part anywhere. Searched online. Anyone got a lead? Or can I just use a 3/8 compression coupler and call it good?