Search results

Hey, someone showed me a tool I absolutely need (really I do :bounce: ) Ayways, it's for punching holes through grommets. Like if you wanted to add an aftermarket wire to go through the firewall through an empty grommet to the batt. The tool has a handle like a screwdriver and a tube that goes...

Ok I think i'm good on the the hand tools and ele test tools and drills now :) I need 2 soldering irons (or gun [is there a difference besides how it's held?]) I've been recommended American Beauty and Snap-on, how do you guys feel about those? I'm looking to buy an electric and butane iron or...

I can't understand your 2nd sentence, "If Klien makes it, but it." was that supposed to be buy it or was there more to the sentence? Yeah a guy at BB told me it's not a bad job as long as i'm willing to be brainwashed lol I'll go to BB get my experience and tools stay for about a year than go...

I'm hopefully getting a job (had 3 interviews today at Best Buy) to do car audio, security, remote start etc... install. For this job I must provide my own tools. Since I will be doing this all day I want reliable tools that will be there when I need it. Here's what I plan on getting: Klein...

I'm gonna be doing it in 10 foot sections by framing it up with 2X6's

Sorry I'm a newb Don't know anything about a plate tamper or jumping jack tamper. Can I get them in 110V if not do they have gas or pneumatic ones? I'm assuming Home Depot. will rent me out one? Any special type/sive of gravel? Also what is a vapor retarder? How far apart should I lay the...

I'm planning on laying concrete down in a 20 X 40 foot barn. The problem is the barn housed horses for years so the ground is 1/2 dirt and half decomposed hay so the ground is very soft. Can I lay cement over it? What if I use rebar? I don't have much experience with laying cement so any other...

I heat my 2-car garage with a propane heater (with 2 heating elements) run it full blast for 1/2 hour then turn one off and the other on low. One tank will last you 1 engine swap :rocker:

Why do you guys say you'd only buy Snap-on if you used them everyday?

As far as Craftsman, Mac, Snap-on etc... Are there any major differences between their tools? Are they made out of different grades of steel, or do they have different ergonomics? Or do people buy them cuz they're shiny and expensive and like to tell people they have them lol? I own all...