Search results

Mike do you care to share what torque wrench you are using on the Transmission Pan? I just recently purchased an older Side by side and it is in need of some maintenance and I need to add a smaller Torque Wrench to my home kit to keep from dragging another tool back and forth from work.

you went all out with the remote IO, those Click's are pretty easy to program. Jason

Strouty, Have you tried Trello or Asana for your Tasks? https://trello.com/ https://asana.com/

My Apologies if I came across as you did not know what you were doing with this. Just sharing information that i have learned the hard way for myself. And again the pipe work looks amazing. Jason

Looks Beautiful, I finally see what you were doing with the 2" Pipes. I have found that when soldering if you work bottom up you have less of a chance of flowing the solder out of the previous joint, YMMV Jason

Logan, We are doing alright over here, My wife's 6 month old explorer did not fair to well yesterday, dam hail, It has a trip to the body shop in it's future. one of my coworkers said that when he came in yesterday (5:00am) his rain gauge showed 7.5" of rain overnight. The last front came...

Logan, I have seen where they will hose clamp the Spring back together as a stop gap until a new spring can get installed. Normally this was on large commercial doors that have special springs that they did not have in stock. Jason

Logan, Fremont appears to have been on the edge of that Storm on Friday, we just got a ton of rain.

Pat, Thank you for taking the time to post. It is not a trivial amount of time to put something together like that for some random guy online asking you questions. Our shop upgraded from a High Def Plasma almost 3 years ago now to a Flow 87K waterjet, We do a lot of Food Grade stainless steel...

Pat, First of all thank you for the little tidbits of sheet metal forming knowledge you are sharing. My day job in in a custom fab shop and I am trying to get through the heads here that you cannot just add up the inside dimensions and figure out what you flat dimension is going to be. I have...

I think that ours was more Sleet than snow however, that's what is sounded like as it was hitting the building anyway.

We had just a dusting here, already gone.

Front Shaft is a Resolver to tell the control where the press is in the stroke.

Top Notch Work As Always Mike Jason

Mike, In my humble opinion you should just keep doing what you are doing, FWIW I do not think that you are being "Preachy".

Wila had a cool looking Vertical drawer Die storage cabinet on display at Fabtec, Looked similar to this one: https://fabtooling.com/products/4-w

Thank you for all of your recommendations, Going to first Try a Straight Dual Air Chuck and if that does not work well I will go the extension route.

Thanks, I will look into this also and see if it will work.

msharley, I will look into this and see if it will work in my application. Thanks,

seber, we have a dual tire chuck but you cannot get the proper angle on it due to the small openings in the rims.