Search results

I have a really nice Pioneer receiver and Polk 7.1 system that was used in a high-end home theater for years. I don't watch TV or movies anymore, haven't in years, so this is just taking up room in a closet. I'd like to move it all to our new building for playing music throughout. I'm in the...

I am working through insulating a 24x50x12, doing 1.5" polyiso w/ a 0.75" air gap and encapsulated closed cell bubble as an interior skin for now - debatably R28-32 range. All air gaps vent upward to the roof ridge vent behind the insulation for moisture control. I'm going to do the frameouts...

I am stuck in analysis-paralysis for insulation and interior finishing options on our 24x50. Electrical is done. My original plan was: Insulation: PolyISO panels with a small air gap (furring strip width) from the metal siding, then skin over it. Wall/Skin: Debating between BlueTex...

Does anyone have a cross-sectional drawing or illustration showing the proper installation method for PolyIso foam board in a steel building? I have a local supplier ready to deliver a truckload, but I can't seem to find consensus on the proper installation method. 1) What is the recommended...

My building is going up next week. I took the week off to organize and finish out some areas. Electricity is a project for next year (200' trench through solid granite, plus an extra distribution box at my meter, going to be lots of fun). Under normal circumstances, I would tell anyone to run...

Our new shop is going in next month. It's about 150' from my primary garages, all downhill. I plan on keeping my tool boxes in the climate-controlled garage attached to my house for the time being. I don't mind walking up the hill and back a few times to get tools, but it becomes a hike after...

[NOT A POLITICAL DISCUSSION] I'm curious if anyone has insight on the potential effects from tariffs on steel building prices. I have been working on site prep for a 30x60 for the last two years (long story, huge undertaking, not the point). My plan was to finish grading and pour a slab this...

I went to disconnect and stow the MaxJax M6 today and one of the quick couplers is completely stuck. I can get the sleeve up so that the ball bearing is about level with it, maybe 1-2mm from the point where it would normally disconnect. I can push inward and feel it "spring" back, but I cannot...