Search results

It would take me all day to show all of mine. LOL They are all my favorite. Love my tools!

Show me the.... "best thing you have ever bought"

So... Every-time my brother shows up... which is about once a year. I like to show him all my new tools. That's our thing. I say.... Wholly ****! "I think this is the best thing I've ever bought!" I then show him about ten things that I bought, That are all "The best thing I ever bought" I...

Especially when you are constantly revamping your shop. Like me :beer:

I keep a spot in my toolbox for old tools that I may be able to make something with. Like these cheap impact sockets... That I should have thrown away... but one day I decided I needed to make a couple drill chuck tools. They are 3/8" drive. Now I can use a 3/8" drive ratchet to tighten my drill...

I keep a spot in my toolbox for old tools that I may be able to make something with. Like these cheap impact sockets... That I should have thrown away... but one day I decided I needed to make a couple drill chuck tools. They are 3/8" drive. Now I can use a 3/8" drive ratchet to tighten my drill...

I agree that your solution is a really good one and I really like the way you went about it and set it all up! I ALSO really appreciate the fact that you see the advantage of possibly using The Tool Swing. I appreciate that! The thing that I want to point out here (because you brought up a...

Love my set. Haven't stripped a head since I got them. 7 years. Motorcycle carb screws are no problem since I got these.

Thank you! I appreciate that!

On a shelf near the last place you took a leak???

Did you check in the beer fridge? :beer:

Did you check your back pocket?

Back in 2008... when I first launched this... I did a test, with the smaller single crank version (I offered at that time), with some leverage and a lot of weight added...it took over 4600Lbs... without any damage. I lost all of that footage over time (so I didn't want to mention it without any...

I would think a couple pieces of angle iron or some uni-strut welded to the front and rear under braces would be more than enough. Bolt it to those and you should be good to go.

One thing about The Tool Swing is.. You are adding more bench space. They never take up space on TOP of your workbench. Which could be argued as the most important space in many shops. Very good points but in the end.... room for more tools for you.

So... I did a little research... You would have to hit The Tool Swing with around 87,000 psi. For a failure. The 2 platforms are held up and together with two 5/8" 1018 cold rolled threaded steel rods with each one having 43,500 psi of "shear strength". The hardest sledge hammer hit is going to...

Thanks for the kind words. I really appreciate it. Really.. I do...Just want to add....I've been beating on and using them in my shop for over 20 years. I also want to add... They will take whatever you can throw at them. Honestly.... Just want to get a real discussion started about this. What...

Thank you!! They were shipped out today with UPS. When you get them. Maybe you can tell everyone that thinks they could bust one.... That it's not likely or more like... impossible. Thanks again. Rich

Thank all of you for the support. I really appreciate it!

Here's what I posted on the other thread: I haven't lost a lot of tools, but when I have, it's because of buddies putting them back away. Not where they're supposed to go. I then find my lost tool in a f'n drawer that's not even close. I now have a rule.... Anyone can grab any f'n tool they...