Search results

Yeah i was reading about that in the paper the other day and our local AACA club sent out a notification of the grand opening celebration you guys were having !! Looks like a nice shop and good prices for renting bays w & w/o a lift plus most tools anyone should need. This is Your page ...

thanks for the video... lots of cracks and big ones in that floor. and the fact that the POLE is rusted up, says that water has BEEN seeping in or coming in that garage for a while. and i would say that the drywall was removed & replaced before they put it on the market considering the small...

what about water seepage up in the cracks or seams ?? you state it got wet in the center first, if it was coming from outside walls you would have a track/ trail of water from the source.

I am using the KBS Coatings Product on my 1929 I am restoring, they offer a LOT of options for various requirements. also they are very helpful and resourceful. call them and ask them anything you want, see what they say. May be able to use Rust Seal and call it a day. just do not get it on you...

Yeah I Know this is a pretty primitive set up but it works, I know have to build by bucket for the Deputy. Simple yet effective, most expensive plumbing part was the hose. if you have spare laying around it should be cheaper. ready to get this into the test mode. and actually blast something ...

Here is the same Setup on my bench with the 90 Elbow and vacuum connected, as well as the Cabinet.

Here is the Setup on my bench with the 45 Elbow and vacuum connected, as well as the Cabinet.

Now on the other end of the Tee you can plug it off, or use a reducer, or plug and drill holes as desired. I found out in my testing that if i had it plugged then there was TOO MUCH Vacuum and it would such in the Plexi Glass viewing window !! so i tried to reduce the suction in the cabinet. I...

after various testing, i came up with my solution for connections and fittings. Sanitary Tee on the Inlet of the Dust Deputy, direction flowing towards vacuum, since this is the flow of the air naturally. then on the vacuum end, i put either the 45 or 90 elbow depending on where and how you...

I then cut a piece of 1.50" sch 40 PVC to about 4 inches long. Then took the Rubber Cap and took a hole saw and cut out a 1.12" hole in the center, or roughly center. This is for the Shop vac hose, since the end is about 1.12" and tapers up to 1.25" i wanted to ensure and easy slip fit that was...