Search results

Thoughts on this table top? It’s (3) 12”x24” plates that are 3/4” thick for a work area of 36”x24”. The aluminum base is machined to allow the plates to be screwed down and made perfectly level. https://fireballtool.com/products/table-topper-36x24

Me and my buddy built a little table last year. It’s 5 x 5 with 3/4 inch plate steel and 1/4” legs. It weighs just a little north of 1000#. Never really understood all the holes in these fabrication tables until I saw my buddy use one. I would definitely like to get some holes in my table but...

I have not done that yet. More than likely what I’ll do is get one of those plastic pieces. I forgot what they are called but they use them in walk-in freezers and warehouses. It’s a piece of thin rubber flexible material. you can get them in whatever width you want by whatever length you need...

For those who have a rollup door and are looking to “seal” the sides., see videos below. Yes, I know you can buy the brushes that you screw to the outside of the building and cost about $100 per door. In my case for two doors, it would’ve been about $190. I went to my local fabric shop and...

Holy sh*t on the water under the ceiling. You have a big problem on your hands.

I’m a diy for last 8 month and use mig with 75/25 gas mix. I just wish I can learn how to strike an arc with stick. FML, I couldn’t do it to save my life

Does this fan move air directly below the fan or does it spread it out?

Simmer down old guy! It was cored 4 months later

Get some cores pulled and tested. I did and paid for 3000 psi concrete. I ended up with less than half of that 😂

My guys went bat sh*t crazy and covered them support brackets. That’s what, 12-14” to the peak? 😂😂

A shrink to tell me how I’m lucky to receive these funds.

What would the cost be for a precast building this size?

Whats the decision factor for determining to go with a mini split VS a central AC unit in your garage? Pros/ Cons to both

Do you have plans for this setup? I’d be interested in possibly putting something like this in my loft once it’s built.

Would the rubberized coating help keep the screws from loosening up?

PM me your email and Ill send you a video of my dilemma with radiant barrier and 2" foam board. I installed both. Had a 2.5" air gap between radiant barrier and siding, the ceiling had a little more air gap. Then foam board attached directly to radiant barrier. After it was up for a few weeks I...

So no bracing is required on the base to keep the column from moving? Yes I have a welder and I’ll be doing it myself. I’m no professional, but I feel confident in my Welds.

The column against the wall is sitting on the concrete footer and it's about 16" thick X 12" wide. The other column is sitting on 6" of concrete. Both baseplates are secured to the concrete with 5/8" threaded rod and is epoxied 6-7" deep. Below is a pic of how I anticipate securing the column to...

Thank you. I appreciate your input

The beam should only show having 1000lbs on it. Yes, a trolley will be on the beam. Pic is when garage was first built. Other pic is how I intend to brace the column.