Search results

I have an old walker floor jack, fluid level is good, there are NO fluid leaks but jack leaks down, I tried to purge system several times of excess air but no luck there any ideas? Thanks

Any threads about restoring one ? Thanks in advance

While disassembly this piece fell out. Not sure where it goes its threaded . Ideas appreciated thanks

recently rebuilt pump and was reassembling. Whats the technique for compressing the spring over the pump assembly? Special tool? thanks

yes you did you sold me what was left in the kit as it was incomplete. I left feedback but the thread regarding your deceptive selling practices was removed.

thanks will pick up a kit. The saddle has 2 shafts holding it to the jack does the upper shaft slide out? It is in very tight. What do you guys use to remove the dial pins that are through the handle support ? the 1/4 inch transverse pins? I tried an old drill bit the drive them out but they are...

THe fluid only drains when the valve is released. Is it possible I have too much fluid in it? I did fill just until it covers the internal cylinder? thanks

Where do you recommend buying a kit? thanks

Do you know of a replacement parts kit for the jack? thanks

I was replying to a question the responder had. I started this thread . Is it possible to hijack your own thread?

I am still using the walker 93642 its a 2.5 ton jack, I was hoping to take the handle support off to do some cleaning but I am unable to remove the pins holding the dials in place. thanks for the help. May need to pick up a kit

I now realize that the release valve assembly is leaking fluid. Is there an O ring that needs replacing inside? Thanks

picked this one up today. I want to disassemble and clean it as it is very dirty, maybe even paint it if I can find the original blue color. If anyone knows please let me know. I am having trouble figuring out how to disassemble the wheel holders from the frame also the rear attachment just tin...

excellent point, thanks

thank you sir

the ball never came out only the stem, thanks

No the handle does not rise when descending. The descent is not as bad as mentioned earlier but still slow. Thanks

Wow . I understand now thanks for clarifying. I have another issue with the jack. I did a quick test with it when first getting it. It would lift the vehicle but I did not realize that it was slowing descending at the same time. I do not see any fluid leaking. Suggestions appreciated, thanks

Thanks for response. As you state it is the drive pins that need to be removed. If I understand they need to be driven out from the inside of the yoke correct? I did buy a replacement have installed and is working well. The jack raises minimally with each stroke of the handle I assume this is...

How can I remove the base support of the handle holder from the jack? It has 2 shafts that need to be removed. Ideas appreciated, thanks