Search results

What size for new 4-wire feeder? 120 feet max distance.

This is the first subpanel in my shop (Square D QO) fed by exterior panel at the house. Every bit of old wire was aluminum which I have replaced with 12/2 w/ground. It will feed a 100A subpanel (Square D QO) via a 50A breaker and 6 gauge wire (2 hots, 1 neutral and 1 ground). I will move grounds...

The green bonding screw is not present in my subpanel.

I've run out of neutral lugs in my subpanel. If I add a grounding bar and relocate all ground wires to it, can I then use the the bar where the ground wires were formerly located as a neutral bar to gain more neutral lugs?

I'm out of neutral lugs on the neutral bar. How can I add more?

In my shop: A Square D 125A QOC24UF subpanel-1 will feed a new Square D 100A QO612L100SCP subpanel-2. In the new subpanel, I'd like 4 circuits, 3-20A circuits and 1-30A circuit. 1. What size breaker in subpanel-1? 2. What size feeder wire to subpanel-2? Thanks in advance

Thanks to all of you!

Should I use stranded or solid wire?

Thanks for the replies, Electrical Dream Team!!!!! Please elaborate on "un-bonding the neutral".

I have an old Dortch electric 3-eye stove that I'm putting in a bunkhouse. Notes Note 1: It is wired with a 3-prong cord. Note 2: It has a grounding terminal on the back of the stove body, located in an area not near the cord connections (8"-10" away). Rating Plate 230V 10260 Watts Breaker...

This is for installation of a Panasonic wall-mounted bath fan. The installation instructions note to drill the hole next to a wall stud.

Thanks for the replies thus far. I'm drilling through Louisiana-Pacific Smart Siding and closed cell foam insulation.

I need to purchase an 8.5" bi-metal hole saw to duct a wall-mounted bath vent fan. Any suggestions on brand and where to purchase? Thanks in advance.

Bosch

Who makes the best (strongest) pointed shovel and where can they be purchased?

Thanks redmondjp!

All of your replies have been very informative to me. Thank you. I would like to pose a couple more questions: 1. Which type of lubrication is best? a. Splash Lubrication b. Full Pressure Lubrication 2. What are are couple of good reputable on-line compressor vendor giants? Thanks in...

Thanks for the replies, thus far...

Phase? Magnetic starter?