Search results

Yes, bump, jiggle, knock, twist - no difference around the battery connection. There is something going on where by turning the motor position slightly, it allows it to start again for that brief moment.

Correct, multiple batteries tried, they work fine in other tools. Turn the motor on the drill> get the half second run time and it quits, turn it to a new spot and try again and its pretty repeatable.

Have a 20v brushless dewalt drill, (can't remember the model # off hand) picked it up to use it today, hit the trigger and it ran for about half a second then nothing. Took it apart and if I turn the motor just a bit, it will run for that half a second and quit again. Does this mean the motor...

Who has the most ball peens laying around? I likely have 10, will have to count em.

Find a good magnetic vise.

Have you actually left it a week to observe that, or did it drop 5-10 lbs over night, and you just assumed it would do that every night after? because if only a single night was observed, thats just the hot air in the tank cooling, and will remain at that pressure after that.

I see a lot of big hefty vises on here, mounted to some light duty work top, or even flimsy tool cart.. Kinda defeats the purpose.

Coulda used you a few days ago! ha There must be versions of this valve that are made with the hole to be triggered by the low pressure condition. Where did you source your valve from? I just got mine from acklands The parts diagram is also not correct in its layout, for whatever reason.

My picture above shows exactly where to get the water out. Just as it leaves the cooler, as the temp just dropped, it releases the moisture. I also have another trap/filter/regulator on the output of the tank, but neither the tank drain, nor it ever see any water really - its all caught at...

Ok I managed to solve it myself - just took some time. I found a tiny hole in the old ruined seal once I cleaned it up, (it was gunked over). This is what allows the pressure to equalize on each side of the seal, and then de pressing the foot pedal bleeds off the back side, tripping the valve to...

CS osborne likely as good as any. Most others are just stamped junk.

I just added one to mine, Pump> cooler> water trap> tank. The line leaving the trap is also up hill to the tank, which should help.

Picked up this machine and the bead blast didn't work - got a new valve, but once I installed it went from never passing air, to non stop passing air, just a continuous leak and the whole machine can't build air pressure now. From what I can tell the foot pedal releases air on the back side of...

Haven't been able to locate a service manual yet, I do have an operators manual though.

Found a number for a rep, and he said they use grease there.

I recently picked up this hunter TC 3500, looking it over I found what looks to be grease fittings on the two arms for the bead breakers? I'm not convinced the lower arm is as strong as it should be, but its a hyd cylinder that controls that, this appears to be for greasing the shaft they...

'Metal band wrench' is similar, but usually has a simple knob on the end to tighten.

That's why I asked worth, not price. Is it chinese junk or worth something

Is this old Buffalo drill press worth much of anything? Plate on the side simply says Model 15 FLOOR

Looks good