Search results

At $119 id make a clamp first. Sent from my SM-J320V using Tapatalk

I'd never spend $89 on one clamp. The harbor freight ones actually work really good. You must have way more money than me. Sent from my SM-J320V using Tapatalk

Otherwise that should be fine if you attach to a proper electrical box. Sent from my SM-J320V using Tapatalk

Your conduit must be properly sized for wire that you run in it. Sent from my SM-J320V using Tapatalk

I've got a few vintage tools to sell but am unsure of where to post. They consist of a few wrenchs, pressed steel sockets, and ratchet repair kits. Sent from my SM-J320V using Tapatalk

Just missing the taps Sent from my SM-J320V using Tapatalk

To make it work you'd need a full 50 amp outlet to feed into. Well, unless the generator only outputs 30 amps. As stated you are better off with a transfer switch though. Sent from my SM-J320V using Tapatalk

Yes, it comes in handy. I made some custom thread inserts for a carburetor that needed to seal, so i made the outside diameter slightly larger than spec. Well, that and to accommodate the inside thread better as the adapter was very thin. Sent from my SM-J320V using Tapatalk

Awesome stuff. A couple dies in that set had a little rust on em that I polished off. I oiled em up, and put an anti rust sheet in the box. Sent from my SM-J320V using Tapatalk

It's awesome to see stuff like that, amazing what they made back then. I bet that it works well. Sent from my SM-J320V using Tapatalk

Lol Sent from my SM-J320V using Tapatalk

I try to keep an extra $50 cash in the glove box for situations like that. Sent from my SM-J320V using Tapatalk

Ratchet straps, basic tool set. Sent from my SM-J320V using Tapatalk

Link is gone Sent from my SM-J320V using Tapatalk

What am I looking at, sizes etc? Sent from my SM-J320V using Tapatalk

Here is my Greenfield ok 311. USS and SAE. All dies are original save for one. Still looking for USS and SAE taps. Sent from my SM-J320V using Tapatalk

I've been buying vintage Greenfield (mostly) sharpining them and using when I need to. Its amazing how cheep that I can find old light use 3tap sets on Ebay. Sent from my SM-J320V using Tapatalk

It can be fun hunting down tools at Estate and garage sales, haggling prices, getting exercise in, researching finds. Sent from my SM-J320V using Tapatalk

Miller's Falls had a similar drive motor and attachment system. Sent from my SM-J320V using Tapatalk

The nc and nf designations were not official until 1947. I read something about ASME specs though in a 60's GtD training manual. Sent from my SM-J320V using Tapatalk