Search results

Search the forum Search Articles
  1. V

    FS: Drill press table lift

    ***SOLD*** This should fit most any drill press with a 2.5 inch column. Not sure of the brand as there are no markings, but I included a Craftsman version label. This includes the lift crank assembly, chain/weight, and column hanger bracket. $200 shipped to the lower 48 or $175 cash/local in...
  2. V

    Vintage Grinder Sticker Reproduction

    Sweet!!! Looking forward to adding this finishing touch to my block. Thanks again :beer:
  3. V

    Show your new tool arrivals

    Needed these for rewiring an oven and it should make stripping the 8 gauge wire a piece of cake.
  4. V

    Where to buy 16' garage door moulding?

    I just went through this after damaging one of my vertical door seals and ended up ordering a kit for both my doors from garagedoorstuff.com. Their seals are flexible and can be easily shipped. Sent from my iPad using Tapatalk
  5. V

    let's see your craftsman block grinders

    Yep... I just sold an extra pedestal stand on CL for $125 and it was only listed for 2 days. Go get it!
  6. V

    2017 Garage Sale Thread

    I saw that one on CL.... Great price! However, I have that same grinder and it is 7 inch. BTW, just looked at your profile and realized you are just east me as we are just north of Twin Lakes :D Sent from my iPad using Tapatalk
  7. V

    let's see your craftsman block grinders

    Agreed. Now I am going back and forth over selling the split phase 3/4 as my new set-up with the Multi-tool on the Commercial will handle all of my bench grinder needs. Yep, that is blockhead blasphemy... but being practical, it would free up some more garage floor real estate for a tool that...
  8. V

    let's see your craftsman block grinders

    Thinned the block herd a bit more today as the 1/2 sold on CL for a tidy profit and takes me down to a pair of 3/4's.
  9. V

    PA Multitool Belt Grinder on Craftsman Block Grinders

    Almost done as one of the last remaining tasks is to enlarge the countersink holes on the disc plate as the 10-24 screws have larger heads than the originals and are not sitting flush (countersink on order). Also think the GFCI issue was resolved as the grinder fires up now without issue. I...
  10. V

    let's see your craftsman block grinders

    Update: The replacement cap was installed last night and the grinder seemed to be working normal. But then after an extended on cycle, the GFCI tripped once again. So to eliminate another variable, I decided to retighten the wire clamp screws in the replacement wall plug. Guess the ground wire...
View older results
Top Bottom