Search results

Yeah Snook you got guys in Pensacola following you as well. It always helps to review the site to get motivated. Larey

Welcome from Pensacola.

Thanks for the replies it was me reading it wrong as I thought it would be per bulb. It is up and running.

I have recently purchased a home in Pensacola Florida nad the previous owner had the house rewired so it would not have aluminum wire in it. My question is as follows. I currently have 2 duplex outlets in the ceiling for lights as that is what I had requested as I brought the previous home...

Doing random searching and never thought of this. I work at the mentioned place above and this may be a future project of mine.

Re: FREE Giveaway - Astro Pneumatic Tools Digital & Dial Tire Inflators | ToolAudits. Could be interesting as I just moved and have yet to hook my compressor back up.

Just says may not meet standards and I have to ship it all back to my distribution center.

I love this little screwdriver. It has small bits that my normal kit does not and for the 5 bucks has been worth it. Used it last to replace a screen on one of my kids dell tablets.

Watch the hand cleaner as where I work, we have a recall in progress for it not meeting standards.

They usually do not put out printable coupons and this is good if you use the store. Online or printable. http://www.oreillyauto.com/site/c/TaxRefund15.oap?icid=bnrTaxRefund15V1D01282015 Hope it may help someone. Larey

Thanks for the input I appreciate it as now I can start to draw the game plan up.

Just bought a pre 1980 home and the garage has crappy paneling in it and one wall meets the kitchen. So the question at hand is I already have to pull the paneling down due to a water leak and what should I replace it with? I am tempted to use plywood so I can remove for future needs as the...

Any update looking for a similar setup.

Oh and thanks for the help from all of you that pitched in.

Well the unit was empty, and it ended up being a pin hole at the top of the coil right before the fins. Tech fixed it and serviced for 274.

As you can see I have an oily residue above the warning label.

Acmikee so with y and c terminal I have about 26 v. Now when I jumper my low pressure switch on the board outside it works so I assume I have a leak or low pressure.

I have tested the contactor with a meter lead by pushing it in, I will take better pictures in the morning, so hopefully that is it...but what about the two resistors?

http://www.amazon.com/Goodman-Amana-Janitrol-Capacitor-CAP050450440RTS/dp/B008I6VBS8/ref=sr_1_1?ie=UTF8&qid=1416886609&sr=8-1&keywords=CAP050450440RTS This is what it looks like, has three sets of plugs on the top, one labeled fan, then one labeled C, the last one says HERM. SO I just found...

Tells me to discharge it thru a 20-30 ohm resistor prior to testing dont have one available at the moment.