Search results

The adapter for the rivet gun/air hammer is colloquially known as a "screw knocker". Had those in aircraft tool boxes as far back as I can remember, and they were old even then.

Looking for a complete set of installation tools for Dzus FA or FJ size 6 fasteners. There should be 6 pieces total, 3 drivers and 3 receivers.

Try rubber bumper plugs in your search terms.

We used to have a couple of our compressors installed more than a mile down pipe from our receivers... Main batch of compressors were about 100 feet from the receiver room.

Might need to play with blasting pressure some. I know that with glass beads you need to turn it down quite a bit.

Was in and out of the Phoenix area during a couple of summers, years back. The concrete trucks started rolling just after midnight and were off the road by about 8 am on the projects I went by.

I've had nothing but Weller or Hakko on my bench or where I worked.

Another big advantage is being able to tailor the air flow to the need. You can run a BA at near zero rpms and get airflow with it being almost silent. You can dial it up to max and get tons of air flow and still be able to carry on a conversation at normal voice levels while standing within a...

Looks like it's could be for Dzus 1/4 turn panel studs.

May end up having to make your own out of plate steel. I've seen nuts so tight that they had to use a backhoe to hammer one loose. Taking it to a cylinder shop and letting them go thru it may be the best in the long run and least frustrating.