Search results

yes, corn cob is a generic term for them, schruppen frasser is the german ones we used at the Royal Australian Mint (1985-1993) on the cnc milling machine. They were fast...e.g. 10mm cobolt end mill running at 4500 rpm and 10m/min. The coolant had to flood the work surface to keep cool and to...

hey, look up "Shrupenfrasser" end mills, I used to use them on the cnc mills back in the early 90's, very clean rapid removal with very low vibration.

Are they ever finished? Had to lift the bed to fit a trunk floor to stow away stuff like spare wheel, tools, jack and fuel can. Took a day to undo and disconnect everything and support the fuel tank. Then added the floor ( minor miss calculation on depth to be rectified) and reassembled everything.

Thanks, I am pretty happy about it too, I still have a lot to do before checking out of here.

Mate, you were so lucky.

the sewer trench is 56m long, it took 143 man hours to just excavate to depth. The last pic from furthest man to closest man took two days to jack hammer out. Yes, granite. This where I found out again who my mates were. One loaned me the 5 tonne machine for 4 weeks for free, just had to service...

I have burnished all the floors myself, walking a total of 18 kilometers it worked out to be. Every room have 4 passes of each grade, 8 grades, 400m2 of floors. Each pass would go wall to wall ( heel to toe) and offset 200mm or 8" each time. The headphones and music made it a bit easier for 2...

Yes we have done a little to the house, but have had a bit of a set back. The seal between the back wall and the concrete roof has failed on the west wing. It lasted for 8 years and cecum to the UV rays of our area, we get -15C to 40C in this area. I have contacted a couple of water proofer to...

Well that is fantastic news for the house and the work light, I have been replacing halogen lights around here since 5 years ago, when our area got to $0.52c per kilowatt hour. power bills went to $1200 per quarter, now back down to $800, even the 13 driveway lights are led barrels ( they can be...

Great attitude, mine is now down to 0.015 and I am trying to kep it there.

Love the work and detail on your car and great work on the table, do you have a single tooth fly cutter to skim over the entire surface in a few passes?