Search results

I have no experience with Konnected GDO Blaq, but I'm guessing they use the ESPHome integration to HA? - I have configured my HA to crack the garage doors when the inside temperature is warmer than the outside temp. I went with the Ratgdo32 solution which uses the same interface and was...

Both actually, although because the slider is offset by 22 inches or so to the left of the blade, it is better at supporting the full sheet when ripping than it is when crosscutting. - when crosscutting there is just too much weight to the right of the blade.

I added the Harvey sliding crosscut to my sawstop table saw. Its not quite as good as a 'real' slider, but it sure does help when ripping full sized sheetgoods. https://www.harveywoodworking.com/products/compass-st-1500-sliding-table

Moments like these are when my wife starts shaking her head and calls me a nerd... - I was peacefully browsing the interwebs looking for ideas for my next adventure when I came across this and proudly exclaimed... I know that Garage!!!

Should have know that you are way ahead of me on the design.. ;)

Mike, pls excuse my very rudimentary picture editing skills, im sure there are lots of folks here who could mock this up properly for you... But just a thought, - is there a play here, where you could section and swap the left and right sides of the bumper? - something like this...

I've bookmarked this guy, just in case I ever need to do something like that... - He seems to really know what he is doing. https://ipfracing.com/

not to nit-pick, but that should be x 5 days/week giving you 24 years.....

Mike, - no, unfortunately there is no way to set a default. your devices will (should) connect to the strongest signal. however, some devices (like a cell phone) that move around the property don't always re-connect to another signal source even if it is stronger. - The easiest work around is...

There is a fairly crude lettering function built into Bambu Studio. - But it makes it easy to change the color of the letters themselves. If I need lettering, I usually build my part in Fusion 360 without letters and add them in Bambu studio.

Gregor, Sticking with the 42mm base makes sense, but @lilscorpion had a great idea a while back of using 1/2 size base standard for the bins (i.e. 21mm spacing). It adds to the flexibility of placing the bins on the grid and doesn't detract anything from the stability. Yes you have to do a...

John Bridge is gone... :-(

I dont know how big your drone is, but have you tried using that to blow them off?

@slodat

Gregor, glad to see you are still doing well. +1 on the Fusion 360 recommendation. Lots of Great YouTube videos teaching all the basics completely free. I have also struggled with the placement of the printer. I had it in my office initially and loved that I could monitor progress constantly...

I love mine as well, my only caution to folks is to make sure you set the torque setting correct on whatever driver you use. - I didn't realize that rivnuts were strong enough to strip the threads off the tool. - lesson learned (the hard way).

Yep, those are the ones.

Don't forget about the hinges. Just google 'garage door green hinges' - They have a spring that forces the door close to the wall, thereby eliminating the gap down the sides. (Thanks to @slodat for that one)

When I did mine, I also went with a linear drain, but I felt like it was important to put it on the same wall as the shower head. - Main reason is that I believe my OCD would go nuts if I was standing on a floor that sloped either left or right (with my back to the shower head), but I could...

LOL, you may well be right. Mine's a '19 and I have a theory that someone confused Inches and CM's when fitting something together. I wasn't expecting German precision when I bought it, but I swear it's been a long time since I have had to make that many steering adjustments going down a...