Search results

Yes, you need to change the pilot burner orifice if you want it to light properly.

Yes and no,always

There is a lot wrong with the way this is plumbed.I`m sure you will be enlightened when the real plumber comes.No way would that pass code here. No trap? No air gap or high loop on dishwasher drain. And if that is a vent behind the garbage disposal it should go out the roof or a quick vent...

I don`t remember the post ,but here is what google brings up on rear discharge water closet. https://www.google.com/search?q=rear+discharge+water+closet&ie=utf-8&oe=utf-8&aq=t&rls=org.mozilla:en-US:official&client=firefox-a&channel=sb I don`t think it takes a wall carrier ,these are floor mount.

Temporarily unavailable :sad:

This is what is used in the professional world on commercial duct. It may not be the same name brand but it is the same thing. Easy to apply this with a paint brush and water clean up. It will set up but is still somewhat pliable when dried. Make sure to leave the unit fan off until it dries,It...

This ^^^^^^^^^^^^^^^^. Thread

Don`t waste your time. Trust me. I had a bathtub reglazed twice,it does`nt last. Waste of time and money.

I have a 1/2 " pex line made for water ,holding 150 psi for 3 years now with no issues. Extreme heat [over 130 degrees f in my pole barn in july],to extreme cold [-20 degrees f ]this winter. I am going to re plumb my whole shop with it as I have quite a bit left over from a rental plumbing job...

Looks like a seal driver kit.

Toggle bolts. https://www.google.com/search?q=toggle+bolts&client=firefox-a&hs=BCn&rls=org.mozilla:en-US:official&channel=sb&tbm=isch&tbo=u&source=univ&sa=X&ei=l2QUU4a9AsjcyQHq0IDQCg&ved=0CFkQsAQ&biw=1366&bih=585

Yes that resistor will get very hot. Most people don`t know this but it is faster to defrost the windshield on low or medium fan speed due to that resistor putting off heat. Also that resistor needs to be cooled off with the air flow or it will burn up .

A tank of acetylene is 50% acetylene 50% acetone. The acetylene is dissolved in the acetone to keep it stable. Safe fill pressure for acetylene tanks are 250 psi at 70 degrees f.

That is really cool. I found some on evil bay ,kinda pricey. http://www.ebay.com/bhp/pulley-light

x3 ^^^

Ever hear of cold forging?

http://terminalsupplyco.com/

From everything I could find ,that unit model number does`nt exist.:confused: I think I would call Trane and see what they say about it.

LMAO^^^^^^^^^^^^^^^^^^ :spit:

Money laundering?