Search results

2 and 6 might be acceptable if the location was communicated to the homeowner or done at their request. When done without communication, it amounts to making things more difficult for the homeowner. As for labeling number 3 as bad driving, my house is in the middle of 5 acres and 300 feet back...

Wow, what a great deal! Hope the winner is someone who really needs the help getting their shop started.

I am not sure about that - Fed-Ex, USPS, UPS, Amazon - all have demonstrated less than stellar performance over the years at my house. In addition to the latest incident regarding claiming they could not deliver because I was not available when I was, I have experienced all of the following...

Perhaps, your non-regular driver had something to do with your situation, but I personally think regular carriers are deliberately doing this to save themselves time and shift the responsibility to the customer to go to the office and pick up the material, which, of course, also shifts work to...

The last few days have been mostly spent on trying to stain the trim bits to match the main panels. This has been a challenge because some of the trim bits were resized, which left unstained wood and some of them had to be rounded over or beveled, again leaving raw wood. Fascia trim. Base...

That is an interesting opinion you posted. I have been storing my levels horizontally for 34 years and regularly check them by comparing 2 readings taken 180 degrees apart without detecting any problem. How long does it take for this "set" to form? Since most my levels have vials for checking...

Really sorry to hear about the divorce. Been thru that - it's the pits.

I have a couple of lengths of vinyl downspout attached to the bottom of a wall cabinet in my shop. My levels slide into the downspout. Takes up less wall space then hanging from nails, keeps the dust off them, and provides protection from getting knocked around.

It warmed up enough today I could roll the table saw outside and work on my side panels. And, my shelf pin jig finally arrived in late afternoon. I taped and marked the planned cuts and laid them on the saw to make sure I had my alignment right before flipping the panel over and cutting the...

Phase 5 of my Armoire repurposing is complete. The first task was to repurpose the riser so that I could use it in the master bedroom where I moved the old tv. I ran masking tape all around the back part of the riser and then ran the riser through the table saw to remove the back 4.5 inches. I...