Search results

I used a cheap but that had a wide head on the top and thought they were going in too loose so ground a little off of the tip and think the expansion sleeves are maybe messed up now in the holes. How do I remove the wedge bolts now

The one to the far right and the same one on the opposite side aren’t tight yet

I’m installing my 2 post lift and 5 out of the 7 are tightening up okay but the other 2 just keep pulling up what do I do??

The forward seem like a good brand? Can I ask how much that one was?

I’ve got a couple 4 door long bed and one four door short dodge Cummins that would go on it I’ve never weighed them so wasn’t sure.

Just 4 door everyday driver truck empty.

Wanted to see if anyone else on here frequently uses a 10k lift for 3/4-1 ton diesel truck on or not?? Hate to spend $9k and up for a 12k if not needed.

That’s what I’m looking at getting! I have a 30x40 and can’t decide how many to get

I normally wouldn’t be on here making threads or looking but been waiting on the doctor for couple hours and we haven’t started yet so it’s safe lol

You’re right I’ll edit it some thanks! I looked at those but sounds like I may stay away from them now thanks! My shop time will be limited soon as well as me and the wife are at the hospital waiting to have ours any minute now lol

Wanting to see some good options of lights to order for my 30x40 shop I’ve been looking at the hyperlite brand on Amazon but wanted to see what everyone is using first. Ceiling at 11’ high will have barn metal up throughout the shop. I looked at some other threads but seemed dated hopefully...

They don’t appear to be built on site I don’t believe but could be wrong

I’m not sure why it didn’t show up but I edited it in now.

And what is everyone using for a vapor barrier?

Wanting to take out to truss supports for when I put my metal ceiling up but wanted to see if anyone else has done the same or left them.

I’ve seen some people do it on YouTube but didn’t know if anyone on here has or if it’s a good idea or not

Would 12k btu be enough you think? Mr. Cool recommends 36k I think for 1500 sq ft

Like to get as much clearance as I can on two trusses, not a very big snow load where I’m at normally. No permit needed I don’t think but not sure how that works.

Ya 30’ wide (direction of the trusses) and 40’ long