Search results

So handsome Kevin

Hey Woods, Been laying low, sorry no Christmas fab. Been working on an aluminum utility bed for a 2024 F-350, lately. Royce

A generous donation for the benefit of your community. Well done Kevin Royce

Senlow, Sounds like we set up the same way, which is what Kevin steered me to. Royce

Cam, The jaws for this vise are channel shaped, so on the vise, there is three surfaces that need cut on both the static and dynamic. The top and face are cut with an end mill and the bottom is cut with a t-slot cutter. So then the slide is set up parallel and perpendicular to the machine...

VOH, I would guess 20 lbs to raise all the way and 100 lbs to lower all the way. Royce

Measured up the vise and sent them to the jaw maker and the decision to true up the faces was made. After chasing my tail for a few hours, finally got it set up and started cutting. Royce

Well then, cut the press down to 1/2" My bride likes her's thinner and wet done, so she formed a 1/4"x6" patty and I went for the 1/2"x 4-1/2". Cooked 4 min per side, with pepper jack cheese Garnished with mayo, lettuce, tomato and onion, on an onion roll. Not bad, if I don't say so myself. Royce

Nah, a Weber!!!

Oh man I'm in trouble, I can barely hold a tenth of a foot

Congratulations, looks great. Royce

**** Howdy, that looks delicious Royce

Just got a new gas grill, first one ever, we always have used charcoal before. It cooks a fine steak and I'm working on getting consistently good burger out of it. After researching some, decided to make a burger press for uniformity in diameter and thickness Started with a pvc female adapter, a...

Been out a couple times, also did some capsize drills and happy that the flotation is adequate and was able to self rescue. Anyhow carved a rowing seat out of ethafoam, it sets good. Also made a couple mast supports for trailering, I'll trim the foam when the glues sets up. Royce

Thanks Cam, been wanting for an outside table for awhile. Royce

Thanks Rock, Don't mind the time it takes, if the form and function work out. I think I got a line on some jaws from my buddy. Royce

Thanks Larry, Actually the shelf is made from 1/2" phenolic sheet from a bowling lane. Tough and weather proof. Royce

Highlighted the vise lettering and mounted it this morning. Short of replacing the jaws, this project is complete. Royce

Thanks Senlow, I came across this paint by responding to a free craigslist ad, 5 gallons of yellow primer and 5 gallons of top coat. Lucky I am! Royce

Also added some pin stripes, not hotrod quality but plenty good enough for a work bench. Royce