Search results

Everything's US made: 1) SOLD Snap-On S832 ratchet - $50 - black oxide, 10" long, 32 tooth. Good condition with wear on handle, sides of head, directional switch. No rust. On right in pictures. SOLD 2) SOLD Snap-On SL832 ratchet - $80 - black oxide, 15" long, 32 tooth. Great condition. No...

I was perusing the Old Drill Press thread today, and spotted a few great Arcs of Shame. Here's the one on my Walker-Turner...let's see some more! _DSC1881 by GirchyGirchy, on Flickr

Last week I did another search on the local CL for bandsaws, and the top one was a vintage Craftsman 103.24260. Pictures looked ok, but didn't show too much detail. It's a 12" model and had a 1/3 hp Craftsman motor installed, for $70. Mounted on the original stand and had a light. What I...

A couple of weeks ago I tore down my leaking Bostitch N60FN to clean and rebuild it. To get ready I ordered some Hitachi cleaner/degreaser and (what I thought was) pneumatic nailer oil. I wasn't sure if this would be the same as normal air-tool oil, but ordered it anyway. So it comes and it's...

Everyone, This afternoon I installed some crown molding in one of the upstairs bedrooms, using my Bostitch N60 I drug out of the trash a few years ago. It leaked air and needed a new trigger valve, and now appears to need an O-ring kit as well (leaking out the exhuast). Anyway, I noticed...

Hey everyone, Hoping to get some advice. I'm getting ready to run a natural gas line in my basement and outside to the deck for a grill. I have the path laid out but can't quite decide where to drill to get the line outside. The line going out is 1/2". I had planned on drilling through the...

Guys, Hoping you could help out. I have a new entry door for my garage waiting to be installed. It's pre-hung, so it has a threshold at the bottom. Problem is, the current door opening has none - it's hanging above the concrete block foundation with roughly filled in holes, so basically no...

Everyone, I was hoping for some help. I've ordered a Weber Genesis 330 NG and at some point will need to get the plumbing ready for it. I have a path pretty well picked out but am concerned about the sizing. The grill puts out a max of 60k BTU, or 55 cubic ft/hr. The line I'm hoping to use...

After getting my drill press, a bandsaw was next on the list. Did a search and found this guy. It's a 14" Bett Marr, sounds like it works fine, and the guy wants $95. Only negative is that it might be an hour away....even so, not terrible. Couldn't find much info on the brand, but the...

I've been keeping my eye on older drill presses on CL recently and think I found a keeper. It's a Walker-Turner Light-Heavyweight, looks to be a 1200 Series floor model. From pictures it's generally crusty but looks like it could be cleaned up. The ad says it works, and they only want $50...