Search results

Looking for help with identification with this box, mostly because I need a slide. The patent on the slide 3,033,638 goes back to the inventor John Tomlinson and later shows up under Waterloo. Thank you for any help

http://www.garagejournal.com/forum/showthread.php?t=267784 I don't know much about it, it does work with just an on/off switch, high rpm. $100 shipped but I would really be open to trades such as 1/2 drive impact sockets, standard flare nut wrenches, body hammers and dollies, must be US made

I read the thread here and now I would like to have one, looking for a kra-65 b or c? Not looking to pay crazy money. Thanks

High rpm motor, scrub brake, any ideas?

I brought home some guns my father was going to get rid of and I will probably keep a few and I have an idea which ones but I don't know much about them as most of what I have used were gravity fed. Also if I do sell the others probably locally what is a going rate for them? 2 binks model 7...

I bought a used Matco tap and die set and things are a mess can someone post a diagram or map of the order they should be in so I can sort though and see what is missing? I found a snap on one but when I enlarge the picture it becomes too blurry, Similar to this

I have a stanley powerlock II 33-425, I would like it if it retracted better. Can I take it apart and lube it or tighten the spring? I saw something where they talked about removing the perimeter screws and not the center and things will not get out of place, is this true?

I am mostly looking for a gauge to tell me air pressure. I need to set the air pressure on my kerosene torpedo heater at 3.5 psi. I was thinking instead of buying just an air pressure gauge why not get one that gives vacuum readings as well. I looked at local pawn shops and two of them had Mac...

looking for snap on brass hammer BH 16 or if you have another brass hammer send me a picture

I am wondering if someone can tell me more about bronze, brass, and copper hammers? I need to rebuild a manual trans so I am kind of looking at brass punches/drifts and thought maybe a brass hammer would be a good idea as well. I also saw if you are going to hit another hammer someone...

I do not have much for 1/2 drive sockets. I have complete standard and metric, deep and shallow 3/8 sk in a case and 1/4 snap on in a case. I like the idea of a case or a set. I do have 1/2 drive metric sockets taken care of with a deep cornwell set and a shallow mac set. Any thoughts? I was...

Just picked this up on saturday and started looking at it. I have not transfered anything over yet. The way some of the drawers move I might pull all of them out and clean and lube the slides. This is not really the box I wanted but it should work for now. My major complaint is that every drawer...

I just picked up two easco wrenches for a dollar each yesterday at a local flea market. Can anyone tell me about easco? When I search for the company I come up with craftsman. Can anyone put a date on these wrenches. I just picked them up because I liked them now I would like to find a few more...

I bough two easco wrenches today at a second hand store and would like to add a few more to them of the same design. Kind of looking for 3/8, 9/16, 5/8, 11/16. I may be interested in more but I will start here. Thank you

looking for a snap on double open end brake wrench B1351A 3/16 and 1/4 for adjusting my jeep brakes

I am looking for some regular craftsman raised panel wrenches . Not looking for complete sets just a few to fill in. I do not pay pal I have a strong dislike for it but I am honest and willing to send a check or if you must I am willing to do a usps money order . 1 1/16 ,1 1/8 ,1 1/4 then...