Search results

Hi Everyone I have few air compressor lubricator personally I prefer use few drops of oil in my tool before use so I was thinking to modify the lubricator ( removing the pick up hose from the ball and close the screw all the way in )and insert silica gel inside the ball so it can be use as...

Hi! I need help how to wire 2 receptacle together both receptacle are used for a machines ( miller 211 mig and a plasma cutter 50d ) that draw 25 amp My set up is a cart with the plasma and the mig on a double gang receptacle box with one L6-30 and one 6-50r receptacle in attached to 35'...

Hi ! Help needed for shop remodeling I have a 24x24x8ft ceiling garage with a divider load bearing wall in the middle I would like to remove a 12ft section of the wall will a 2pc 2x12 header be sufficient for that span of opening? The trusses they run perpendicular to the wall in question above...

Hi! everyone I need help to diagnose this problem I have a a 5 hp air-compressor 220 v 21 amp in a dedicated breaker connected by 10/2 wire(1 white 1 black and 1 grey wire) with a manual cut off switch by compressor I check for voltage at the switch, pressure switch, and the motor both the...

Hi! My first post here. I want to thank all the member for all the knowledge and information that you guys share. My current project is relocating a 80 gal compressor in my shop attic and replacing the pump for more cfm to be able to media blasting my old pump is a kellog 321 1hp motor my...