Search results

Not entirely sure how I managed this. This is an IR 231A. I tore it apart to clean, lube and replace all the gaskets. I've got the gasket kit, so I started reassembly. I warmed the body up with propane torch similar to the way I did when removing the piece . It didn't drop all the way in, so I...

So Ive taken apart, cleaned up and upgraded this old craftsman block grinder that I got a while back. I wanted a fine wire wheel on one side and the grinding wheel on the other side. After lots of searching, I found a solution for a fine wire wheel that didnt have the little 5/8 to 1/2 arbor...

I picked up a yost vise a while ago and havent gotten around to fixing it up yet. Aside from the obvious rust in the pic, there is a bit of rust where the screw passes through. The white is just a little wax (tried to keep it from getting any worse). Im deciding between having the whole thing...

Ive read most of the posts about vises and started looking for a decent vise a while ago. I recently stumbled across this vise on craigslist. I thought it was a wilton bullet, but the slide is square. It doesn't really have any identifying marks on it other than what you see. I would guess...