Search results

I have a scissor truss roof system and the roof itself is fully finished with vapor barriers, vents, roofing, etc. Located in upstate, NY and subject to significant temperature and humidity fluctuations. After the heater (only to be used on demand) is installed, we will be insulating the...

Compressor Air: When to use a Filter-Regulator-LUBRICATOR??? I am currently using rubber air hoses that are hanging on hooks but I will soon be going to the Rapidair 3/4" FASTPIPE system. I will NOT be sandblasting. The air is used for air tools, lift safety locks and a rolling jack. I...

I'm looking at purchasing a *new* 5hp, 80 gallon, vertical, 2 stage compressor that delivers ~ 17.3 CFM @ 175 PSI for a home shop/hobbyist type usage. This is probably a little more than I need but I would rather have a unit that lasts for 30 years with proper maintenance. I've seen similar...

Footprint: 36' wide (2 bays & workshop), 24' deep footprint. Roof: 12'x12' pitch 1st Floor Height: 10' Location: Hudson Valley, NY State Does anyone have a rough cost savings idea when using a truss system instead of dimensional lumber to build the roof system? All work would be highered...

I will be building a garage (2 bays & workshop) and I plan on installing a 4 post lift in one bay. Therefore I need clearance above the lift and conventional garage door systems roll up and over the car at the ceiling height. I am looking for around 12'-14' of clearance above the center part...