Search results

https://strictlytoolboxes.com/product/36-montezuma-tool-boxes-portable-tool-box-xl450b/ This was a great idea at the time, complete tool box inside my parts warehouse instead of going next door to my repair shop for the big tool box. It was unpacked, setup and opened a few times before I...

About 100 Akro Mils Plastic Bins. For 12" shelving. 4" tall. Mostly 4" wide, quite a few 2" wide, and a few 6" wide. Most have been cleaned in Dishwasher but need some cleaning with alcohol to be nice. I continue to add to the stack so there will be 5-10% more than shown. Located in Upland...

Inland So Cal location so generally I would only care about heat RETENTION for a few weeks a year. Have a couple 4x8' plastic bubble skylights on the typical industrial almost flat roof. Getting too much damage from UV and too much heat on the second floor of small parts department as the...

I thought I would post a new thread instead of further hijacking the thread titled "T8 LED tube issue". Thanks, cybrdyke, for the response on that thread. I have a bunch of 3' wide rows in between parts bins with mezzanine above that supports the second floor of the warehouse. They are each lit...

I have these smooth sided, no divider, bins in my parts department. They are for 12" shelves and came 4,6,8,10" wide. Don't remember buying them and they have been around for 25 years at least. Any idea who makes something like this? We use Akro-Mils, Lewis, and Quantum bins with dividers but...

My warehouse has 60' of tall south facing wall that is baked by the hot SoCal sun all day. Since this is SoCal, it is cooked a good 300 days a year. It has two whirlybird vents that move some air most of the time. We might shut off the manual closure a couple weeks a year. I'm planning to add a...

For those of you that have somewhat mobile light duty 3 phase equipment, what outlets/plugs have you used as a standard? I'm going to be moving stuff around for a while and the equipment is likely to end up in a different building than where it started. I'm thinking standardized outlets might...

Some of my conversions are running into problems with the narrow beam angle of LED conversion lamps. I see some are listing beam angles of 180* or even 230*. Still looks like there is one row of LEDs inside instead of two rows at an angle to each other. On the few where they show actual light...

I think we know that the electrical feed to a fixture needs to match the rating of the circuit. 20amp circuit needs to have 12ga wire to each fixture. When we convert a fluorescent fixture to LED, we can use the existing 18-20ga wire to the tombstones because we are inside the fixture, right...

Part of my warehouse needs a continuous run of lighting at 16.5'. The second story of the rest of the warehouse needs every bit of the 9' clearance. Since the roof tapers at each end, I'm left needing lights that fit in between the joists that are 8' centers. So I'm using 8' lighting...