Search results

Hey All, I'm in the process of setting up lines in my shop and I'm looking for some advice on making a decision when it comes drying compressed air. I have a 7.5 HP CH compressor mounted in a shed outside of the shop. I'm going to run the line into the shop through the back wall. The...

The bottom chord of my shop's trusses are pretty uneven (up to 5" in one location). The trusses are set 24" on center and I'd like to put up 5/8" drywall on the ceiling at some point when I am done wiring. Would sistering steel studs to the bottom chord be an acceptable way to get it flat...

I picked up 9 Lithonia IBZ 454 housings high bay housings several years ago when I started my shop renovation and it has been a slow go unfortunately. Since then I've realized that I probably should've waited until I was ready for lighting to make a purchase. But since I've already invested in...

I have a 400amp service at my main panel in my home and I'll be running a 125amp service out to my 48' x 28' 1300 sqft shop in the next few weeks. I am planning the shop wiring right now and I want plenty of room for improvements in the future. I've mapped out a number of 50 amp receptacles...

I would like to rough in a 12' opening versus the 10 foot opening my shop has currently to prep for a garage door install. I am not an engineer and would like someone with a little bit more experience with an opinion on it. here are some images: Currently it is a 10 foot span with a sliding...