Search results

Still on the first tank of mix gas. Brand new backpack leaf blower, 570BTS. Used it last weekend no issues. Started to use it this evening and it didn't sound right. Clack clack clack almost like a rod bearing. Debating on taking it back, I decided to take a look. Two bolts holding the blower...

Good afternoon all. This past Sunday, my cousin gave me his father's drill press and tool box. His father was a WW2 Navy vet and worked as a lineman, camera technician, and camera repairman. He worked at the White Sands where he was responsible for the camera work on the tests. He was my...

I have a huge tank of argon for my tig setup. I also have a refrigerator that has a leak somewhere in the system. I want to pressurize the system with argon to find the leak. I need an adaptor fitting that can screw into the tank regulator and attach a 1/4" sae manifold hose. Male/male...

Dude!!!! He ran wire for a compressor and welder, 60a double pole, 8ga? wire. Said the compressor sparked and breaker popped immediately. What could he have screwed up on his compressor? Lord have mercy.

Does anyone make a set of alligator clips that attach to the factory Fluke 116 leads? I ordered the AC285 clips on bad information and they do not work.

Help me understand the process. Home A/C system is not blowing cold. Breaker is good. Inside fan runs, filter is new. No iced up lines. Condenser fan not running, capacitor is good, fan spins freely. I pull the cover on the condenser unit and the display light on the circuit board shows red...

I have a 240v overhead heater in my shop and want to use it as a blower only to circulate the air. However, the thermostat is keeping the unit from coming on. Anyone familiar with these units? Is there a bypass to kick the fan on without kicking on the heating element?

Came home from work and saw the master bed side of the house was 77 degrees, thermostat set on 74. Cycled it off, on. Blower fan kicked on and stopped after 20 seconds. Could not hear the condenser fan running. 40a 220 breaker was tripped. Reset the breaker and it tripped in a second. Went...

I have a 30'x40'x10' detatched metal shop. The left section with the windows has been framed in and an insulated ceiling added. The size of the room is 14'x30'x8'. All walls in this room have faced insulation rolls in the wall. Paper facing the inside. This is NM where we get hot and cold temps...

I guess I learned to look at all the tools I purchase carefully, no matter how much they cost. I purchased 206FUA a couple weeks ago from the truck. Went to use the 1/2" and it didn't fit my fastener. Looked at it closely and it is a 7/16" stamped with the 1/2" part number :( Gotta call my guy...

What does the A designation denote at the end of XB3234A? I bought a used XB3234 to fill a gap but am curious. Thanks in advance.

I have been trying to contact someone at IR about a broken air drill and have had zero luck. I have sent 4 emails in the span of 2 weeks without hearing a response. Does anyone have a number I can call to talk with a rep? The drill is less than 5 months old. Broke the shaft below the drill...

Bought a ring and pinion gearset on another board from a guy swapping to shorter gears. He called me today and said the shop doing his rearend snapped all twelve bolts. They didn't realize they were left hand thread (after snapping all 12, and were marked L on bolt heads). Set is for a Mopar...