Search results

I just hooked up my 60 gallon 5 hp hf air compressor. It started up fine oil fine its running so let me see if it shuts off when it hits the 165 psi mark as it says in manual. watching gauge here comes 150 psi and there goes the safty valve compressor still running. take a look at safety valve...

I have a 5 hp hf air compressor. I have a 220 line in garage that has 4 wires 2 black 1 white 1 green. Does this sound right I have been told it should be 1 red 1 black and 1 green . does this sound right?

Was looking to by a compressor anyone have any info on the stuff sears offers. I was looking to use sears card i was thinking of getting a campbell hauser maybe the 60 gal 5 hp. any info would help.

I have an old milwalkie 1/2 inch drive drill its the old all silver case no plastic. I was using it and it just stopped I stopped using it let it cool it worked then it stopped again does not work at all now. Anyone know what could be the problem how to fix or does anyone know where i could get...

Anyone know the best way to remove a tapered chuck 3/8 its made by jacobs their instructions say you have to use a wedge that they sell. Anyone have experience with this?

are all mcmaster-carr drill bits made in the usa?

Who makes good american made drill bits? I found hanson at ace hardware colbolt steel made in usa anyone know of any others and where to buy?

How do you tell the difference in years of milwaukee drills?Anyone have part numbers years made? It seems the older the drill the more metal it has with more plastic as the years go by.

I'm replacing the chuck on my 3/8 drill which is keyless with a keyed chuck from jacobs. the screw that holds the chuck to the drill is giving me a tough time its allen head lh thread. when i do get it out somhow should i replace with a flat screw or other type? where could i get that type of...

Who makes high carbon steel usa made with usa steel. I looking at irwin but they use over seas steel " made in usa with global components" Looking for taps dies screw extractors.

Has anyone been to nothern tool latly If you can find somthing mase in the USA good luck. A few years ago i bought a arcan 20 ton hydraulic press the frame is made in the usa but the hydraulic jack made in china it leaks and woks like ****. They seem to have gone with torin presses and jacks...

which hand saw is better for cutting aluminum hack or coping which type of blades should be used.

Where can you find american made bolts screws nuts ?

Has anyone used this I was going to use it on a old wilton vise I'm rebuilding is it worth using or should i just use paint?

Has anyone rebuilt one of these I have a 9300 model and started to clean it up. Anything I should look for or avoid. its in good shape I see there are pins towards the rear of it How do these come out?