Search results

Purchased this Taiwan made 1755 Wilton vise on ebay... against my better judgment. Would you send it back? I was able to repin the guide rail, but the jaws still closes off center. If I push it center while I tighten it stays straight.

Been looking for a good older wilton 1750 for awhile. Prices have gone sky high! Have not found anything local that I really liked. Most are beat to hell or restored and $$$$. I found a 1750 (online) stamped 86, looks to be american made (screw in pipe jaws and solid base) for $300ish + $50...

Decided to finally purchase a brass punch set for my gunsmithing needs (been using steel). The "gunsmith" sets seem to be marked up for what you get. Anyone had good luck with no name sets off amazon? Open to an advise.

USA made Craftsman, mostly G2, G2D, GK from the mid 2000s Unsure on price for these so I am asking $500 OBO shipped. All sockets are 6 point and laser etched. They come on Craftsman socket rails. 1/4th, 3/8in, 1/2in Ratchets. 3x 6" 3/8in extension 2x 3" 1/2in extension 1x 3" 3/8in extension...

I am going to be selling some tools. I am really unsure on the price. Is there a section on these forums I can post it and ask people's opinion on price? Figured I should ask before I type it all up and get the post deleted.

Looking to replace my older USA craftsman wrench set with something newer, its missing some sizes and is pretty beat up. I have looked around and watched some videos but it seems they all have their issues. My requirements, Combo $200 or less for Metric and SAE Offset No skips Non ratchet...

Had been eyeballing a cheap HF vise for awhile now but after reading this forum I decided to visit my local CL and see if I could find anything american made for a decent price. Picked up this Reed #24 for $40. It seems to be in decent condition and everything works. The dynamic jaw pulls out...