Search results

This is a C 600B tool roll, I haven't been able to find out what it holds. Size is 23" x 30".

I've had this since the 1960's, I was told it is for gripping and removing a spring on drum brakes. It works good for that, but I can't find anything about it. The Thermacote Co. back then was a welding supply. Safe-T-Grip, Thermacote Mfg Co Newark NJ

The metal box has Hinsdale embossed on it, but are the tools in there Hinsdale? None of them have any markings, except for the numbers on the sockets.

Have a 1992 John Deere rider with a K Series 12.5hp Kohler engine. The fuel shut-off solenoid has begun leaking gas from around the end where the crimping is. It has also quit working, the pintle is easy to move, but it does not retract when energized. A new one from JD is $100, a cheapie on...

KD 2569 oil pressure sender socket, 3/8" drive

These two things were in a case along with a Starrett dial indicator, and a few other small parts. Any idea what they are for?

2002 Buck 110 automatic knife and leather sheath. The tip of the blade is broken off. Works well.

This was in with some other old sockets, 3/8" drive

Anybody know what this attachment on the screwdriver is for?

Montgomery Wards Powr Kraft 5 pc ignition set, $20 shipped Craftsman 10 pc -V- series combination ignition wrench set, $20 shipped

Older MAC P-6-C curved needle nose pliers. The grips have a very thin rubber coating.

FS: KD 2011 Inner & Outer Snap Ring Pliers Tool. This tool will work on both inner and outer rings, and will hold the snap ring in the desired position while removing. Cash, check or Paypal.

What is this? The square shank is 1/2", with two detent balls. It was in with a bunch of old sockets.

I thought this was a tappet wrench, but the number doesn't match anything I could find. The other side of the head says 1/2

All i can read on the inside of the handle is S & CO

I can't quite read the brand of this copper hammer, anyone know what it says? The handle says Hol-O-Hed. The hammer weighs a little under 3 pounds.

It looks like in one spot there is some writing on the handle, but cant really make it out. It could say Craftsman. Does anyone recognize it as a Cman?

I picked up these two threaders at a sale the other day, most of the tools were from the 40's and 50's. The larger one is a LL-3123, and seems to be 5/16nc thread, a 5/16 nut does thread on. The smaller one is LL-2503, and I thought it looked like 1/4nc, but a 1/4 nut is a tiny bit too small to...

Trying to find out what this tool bag held. I saw one on ebay and one on Piclick, but no info about them. There is a piece of spring steel sown into the seam that is about 13" long. Wondering if anybody knows what thsi kit held, and approximate age.

On the shaft it has KE6, and there may be something else after the 6, can't tell for sure. The socket is 1/2" and has KU166SJ-1. The hex end is 7/16". I looked through the old catalogs online, but could not find this tool.