Search results

I need to make a handle for this 2” chisel with an odd “tang” that’s larger around than any I’ve ever seen. 5/8” diameter but fairly short. 1-3/16” long. There are no markings to identify the manufacturer. Not sure what the handle should look like.

I have an older Senco Model L Brad Nailer. It blows air out the top all the time. I assume that I need to replace the o-rings in the trigger assembly but I cannot figure out how to remove part no. CA0065 from the housing to get to the o-rings.

I posted this in the wrong thread earlier today. I have an older "Corona" hammer that would be soft faced if I could find threaded replacement tips with 5/16-24 threads. Any suggestions?

I have an older "Corona" hammer that would be soft faced if I could find threaded replacement tips with 5/16-24 threads. Any suggestions?

I can't find any identifying info. Anyone know who made this? I need to order a replacement jaw. (Can probably find one that will fit if I look hard enough.)

I have a Columbian bench vise that is welded together, not cast. I don't know whether it's something special or a waste of perfectly good metal. Anyone know what this is? Sorry the photos are upside down. Can't get them flipped.

Looking for a new air compressor for my garage/shop. Any advice would be appreciated. Major uses: Filling tires; Blowing dust; Staples, brads, and finish nails; I own a framing nailer but don’t use it much; Occasionally use a small air hammer to chip cement; I have sand blast cabinet that I...