Search results

Looking for ways to fine tune cradle height without drilling new pin holes. Any ideas? Shown in the pic is, Square Tubes layed across pins front and back of cradle. This raises cradle by about 2inch, and splits the difference between holes and seems to work but it is a bit sketchy.

Set up a new tool cart. Would like to see some other suggestions too Sent from my SM-G955U using Tapatalk

Went to Home Depot today for a M12 Ratchet. But the only way was to buy the tool and battery seperately. So ended up with a impact and driver kit and added the ratchet. Worked out cause it gives me 2 batteries. This ratchet is really good BTW.