Search results

I recently made some welding table clamps for less than $4 that I really enjoy. It only took a few minutes per clamp to make, and all you really need is a grinder, and a welder! I bet you could even use these on a wood workbench to clamp down any other projects you guys might have! Dirt Cheap...

I had a pile of breaker bars and torque wrenches in a pile on my work bench for the last year, they didn't easily fit in my toolboxes, without displacing other tools, so I spent a while trying to figure out a good place to hang them.. and how I should hang them, and I settled on this! I hope...

Recently I decided my center 9x7 garage door were WAY to small. I cant drive my tractor in with the ROPS up, and I had a truck I couldn't drive in because of the lights on the roof! So I found a replacement door for one side of my garage, and use one of the extra panels to extend the center...

I figured I would share some photos of the coating I just put down on my garage floor. The floor itself wasn't in great condition, it had a lot of spalling concrete that I repaired myself, The previous owner never sealed the concrete and after a few years of winter ice it had some big ruts. I...

So, i got a deal on 75 sheets of PolyISO, and i am looking for install recomendations. I could do full sheets ontop of the studs and tyvek tape the seams. Or i could cut it into 2 foot strips, and either tyvek or greatstuff edges. What do you all think?