Search results

I'm in need of a connector that can splice 4 #10 and 1 #8 wire. The application is for the slide power in my RV. From the factory it came with a BIG wire nut, but I've already had one of the wires work it's way out, and it's only been a couple months. I could use a crimp sleeve, but that would...

So I purchased a couple wifi thermostats to replace my existing ones. They require a "C" wire for installation, and neither location currently has one. The first floor location has an unused wire, but I'm not sure where to hook it up. The second floor location I should be able to run a new wire...

So I have a 8x12 outbuilding (actually a 2 story playhouse) that was built by a previous owner. It currently has 12/2 UF feeding it, but it is unprotected where it exits the ground. They also decided they would just throw a standard NEMA 5-15 plug on the end of the wire, and plug it into the...

This is how it's done right? :willy_nil:shocking::shocking:

So I'm going to be installing a multi head mini split in a couple weeks. The wires for the outdoor unit (12AWG THHN) will be run in conduit from the MSP out to a disconnect. I currently have my generator inlet box on the back side of the house. I utilized some existing 8/3 that used to supply...

This spring I bought a house built in the 70's. It's quite odd in a number of ways, including the garage. It's currently uninuslated, and I would like to insulate it next spring to help keep it above freezing during the winter, and not so hot during the summer. My question is, what would be the...

Hello all, newbie from NH here. I have a few questions regarding mini split installs, and you guys seem to have quite a bit of experience. First off, I installed a Mitsubishi HyperHeat 18kBtu unit in my last house, and it was a piece of cake. Recently just bought a new house and I'm looking at...