Search results

I have an attached 6 car garage that has no wall insulation and some ceiling insulation. After pulling in a few hot cars in the Kansas heat (100+ degrees), my garage gets really warm! Last year I installed a Quiet Cool CL-2250 whole garage/home exhaust fan at the highest part of the ceiling...

I have a unique garage layout and am debating the next steps to attempt keeping it somewhat cool in the harsh KS summer months. My garage is a 6 car (split 2 + 4). The 4 car garage is a tandem and the back half (where I do the majority of my car work) has 16 foot ceilings. The ceiling of the...

Over the years, I've tried several white grease markers/pencils for automotive work. I've never found one that marked cleanly, didn't quickly rub off, or the marker itself didn't dry out quickly (often when I needed it the most!). Any recommends for a good quality white grease pencil/marker...

I just had a new home built. In one particular corner of the garage, a very small section of roof has had a small, but persistent leak that the builder cannot identify. The builder had the roofer replace that section of roof (10' x 4') and the builder has temporarily removed the drywall and...

Hi all! I just had my new Bendpak 2-post lift installed today. I recently built my house and knew that I would have a need for 220V service, so I had my builder install a 220V 1ph plug for woodworking tools or a welder. I currently don't have a welder (or anything) plugged into this outlet...

I just put my order in for a Bendpak 10k# 2-post lift. Does anybody have any recommendations for a good (but affordable): Oil/waste drain tank? High lift jack stands? Thanks!

I've been interested in buying the 72" HF glossy red toolbox for several months now and have been waiting for a good "Black Friday" deal to finally pull the trigger. The price hadn't changed from it's usual $1200 on Friday and I was disappointed ... but today the price dropped $100 and that was...

Just built a workbench that will sometimes sit in the middle of my workshop. I have 20A circuit for the workshop wall outlets (all 20A rated components throughout the entire chain). Since the workbench will need to be somewhat mobile, I'm planning on having a home-made power strip attached...

Hey GJ. I've been lurking on this board for quite a while and finally found a tool problem that maybe you guys can help me figure out how to fix. I have a Ryobi DP100 (I think) 10" drill press. I bought this on CL and haven't had the chance to use it until the weekend. The motor runs strong...